HOUSING AS- 4700806 - Caterpillar

Hold (23A) - When you release the lever, the lever returns to the HOLD position. The movement of the bulldozer blade stops.
Tilt Left (23F) - Pull the tilt lever toward the left in order to lower the left side of the bulldozer blade. When you release the lever, the lever returns to the HOLD position.
Tilt Right (23G) - Push the tilt lever toward the right in order to lower the right side of the bulldozer blade. When you release the lever, the lever returns to the HOLD position.Hydraulic Lockout (24)
Illustration 18 g01429368Note: A red colored interlock tab is part of the hydraulic lockout switch. The tab must be lifted and held before the switch can be pressed in either direction. Lift the interlock tab and press the top of the switch in order to deactivate the hydraulic control levers. Lift the interlock tab and press the bottom of the switch in order to activate the hydraulic control levers.
Hydraulic Lockout - The hydraulic lockout switch is used to deactivate the hydraulic control levers. Lift the interlock tab and press the top of the switch in order to deactivate the hydraulic control levers. Deactivate the hydraulic control levers before you exit the seat or before you service the machine. The hydraulic control levers should always be deactivated when the machine is left unattended.
Hydraulic Unlock - Lift the interlock tab and press the bottom of the switch in order to activate the hydraulic controls.Ripper Control (25)
Illustration 19 g03833669
HOLD (25A) - Release the lever. The lever will return to HOLD position. Ripper movement stops.
RAISE (25B) - Move the lever to the left in order to raise the ripper. Release the lever. The lever will return to the HOLD position.
LOWER (25C) - Move the lever to the right in order to lower the ripper. Release the lever. The lever will return to the HOLD position.Adjustable Armrest (right-hand) (26)
Use the following procedure in order to adjust the right-hand armrest, if necessary.
Loosen the knob under the inside of the armrest.
Move the armrest to the desired height.
Tighten the knob.Power Receptacle and Service Port
Illustration 20 g03646395The 12V power receptacle and the Electronic Technician (ET) service port are located in the back right-hand corner of the cab behind the operator seat.Power Receptacle (27)
Power Receptacle - The 12V power receptacle can be used for powering automotive electrical equipment or accessories.Note: Do not use the power receptacle as a lighter for a cigarette.Electronic Technician Service Port (28)
Electronic Technician (ET) - This service port allows service personnel to connect a laptop computer to the machine electronics using Cat Electronic Technician. This connection will allow service personnel to interrogate the machine systems and engine systems.Mirror
For best operator vision, adjust the rear view mirror that is above the front window. Adjust the mirror before you operate the machine and after operators change.Window
Illustration 21 g03646409The right-hand and the left-hand cab windows can be opened by the operator.Use the following procedure to operate the cab window:
Loosen knob (2) of the window lock assembly.
Squeeze latch (1) in order to release