HOUSING GP-FRONT 4832790 - Caterpillar

Introduction
The calibration of a component using the information display allows the ECM module to determine the correct output level. The calibration also allows the ECM to determine the correct input signal for displacement.Some of the components that are connected to the implement ECM can be calibrated by using the Cat® Electronic Technician (Cat® ET) Service Tool.Calibrations should be performed on a surface that is smooth and level.The following implement component calibrations can be performed using the information display:
Left Front Implement Pump Solenoid Calibration
Left Rear Implement Pump Solenoid Calibration
Right Front Implement Pump Solenoid Calibration
Right Rear Implement Pump Solenoid Calibration
Lift Linkage Sensor Calibration
Tilt Linkage Sensor Calibration
Implement Raise Valve #1 Calibration
Implement Lower Valve #1 Calibration
Implement Rackback Valve #1 Calibration
Implement Dump Valve #1 Calibration
Lift Lever Calibration
Tilt Lever CalibrationThe following transmission component calibrations can be performed using the information display:
Torque Converter Pedal Calibration
Impeller Clutch Solenoid CalibrationCalibration Process Using Information Display
Illustration 1 g03892813
Information display - home menu
(1) Service menu button
From the home menu on the information display, select the wrench icon to enter the service menu.
Illustration 2 g03892815
Select "Service Mode".
Illustration 3 g03892819
Enter password.
Illustration 4 g03892821
Select "Enable".
Illustration 5 g03892826
Select "Calibrations".
Illustration 6 g03892844
Choose category of calibration and follow on-screen instructions.The information display will list initial machine conditions that must be satisfied before the ECM will allow the calibration procedure to continue. Follow the specific instructions on the display to complete the calibration procedure.Note: The “CALIBRATION REQUIRED” diagnostic will be active. The ECM will revert to the previous successful calibrated values if a calibration is aborted at any time.