HOUSING 4988946 - Caterpillar

Table 1
9W-1495 Service Meter Kit Parts List    
Part Number     Quantity    
161-3932 Service Meter Gp     1    
114-2505 Film     1    
8L-8413 Cable Strap     15    
200-5719 Wire     1    
9W-1411 Wire     1    Procedure
Remove the 6T-7337 Service Meter Gp from the machine.
Disconnect the signal wire and the ground wire from the 6T-7337 Service Meter Gp . Make note of the color and number of the Ground Wire and the Signal (+) wire.
Depending on the machine model, the original connection terminals will be either separate spade terminals or a 7N-9738 Receptacle Housing . If separate spade terminals are used, go to Step 3.a. If a 7N-9738 Receptacle Housing is used on the 6T-7337 Service Meter Gp , go to Step 3.b.
Connect the signal wire (removed from the 6T-7337 Service Meter Gp ) to Terminal 3 on the new 161-3932 Service Meter Gp . Connect the negative wire (removed from the 6T-7337 Service Meter Gp ) to Terminal 2 (ground) of the new 161-3932 Service Meter Gp . See Illustration 1.
Illustration 1 g00959709
161-3932 Service Meter Gp - Back view
Illustration 2 g00959754
161-3932 Service Meter Gp - Front view
Illustration 3 g01003176
9W-1411 Wire
Connect a 9W-1411 Wire to the 7N-9738 Receptacle Housing as follows:Note: Before disconnecting the 6T-7337 Service Meter Gp , make note of the color and number of the Ground wire and Signal (+) wire.
Connect the wire that went to the positive terminal of the 6T-7337 Service Meter Gp to Terminal 3 (Signal +) on the new 161-3932 Service Meter Gp . See Illustration 1.
Connect the wire that went to the negative terminal of the 6T-7337 Service Meter Gp to Terminal 2 (Ground -) on the new 161-3932 Service Meter Gp . See Illustration 1.
Connect the optional unswitched Battery + connection. When the key is in the Off position, this connection is needed in order to view the service meter. This connection is not necessary for the service meter to properly maintain service hours. The unswitched Battery + connection is for viewing only.
Connect the 200-5719 Wire (provided in the 9W-1495 Service Meter Kit ) to Terminal 1 of the new 161-3932 Service Meter Gp . See Illustration 1.
Locate a fused, unswitched battery + source. An example of an unswitched Battery + source would be the key switch power on the machine.
Route the 200-5719 Wire to the fused, unswitched Battery + source. Connect the 200-5719 Wire to the Battery + source. Note: Caution must be taken when routing this wire. Ensure that this wire is not located in a pinch area or located in an area in which damage to the wire could occur.
To secure the 200-5719 Wire , use 8L-8413 Cable Straps (provided in the 9W-1495 Service Meter Kit ).
Install the 161-3932 Service Meter Gp in the same location as the former 6T-7337 Service Meter Gp .
Check the machine for proper operation.