HOUSING AS-PUMP 4N1956 - Caterpillar

Reweigh Messages
Reweigh messages instruct the operator to reweigh the previous bucket. These messages will be displayed immediately after the bucket has been weighed. These messages are displayed when this application detects an error in the process of the lift. Details of each message are shown below:Weigh W/O Stopping - Lift Stopped During Weigh
This reweigh message appears if the following occurs:
The bucket stops moving while the bucket is in the weigh range
The operator releases the lift lever before the bucket has traveled completely through the weigh rangeWeigh W/O Shifting - Lift Pressure Change During Weigh
This reweigh message will appear when a substantial spike in lift pressure is sensed in the hydraulic system. This event appears when the following occurs:
The machine changes direction while the bucket is in the weigh rangeFully Rackback Bucket - Bucket Not Fully Racked Back
This reweigh message appears if the bucket was not fully racked back while the bucket passed through the weigh range. Reweighing A Bucket
If a reweigh is recommended, the operator can either:
Perform the lift and travel through the weigh range again to generate a scaled weight
Push the estimated weight button to generate an estimated weight without traveling through the weigh range
Ignore the warning and use the existing weight As long as the bucket is not dumped, the load will not be permanently added to the truck weight. Note: An estimated weight is not as accurate as going through a full lift and likely not within the precision spec of this application.