HOUSING-CLUTCH 4S8708 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
C 1P-1863 Retaining Ring Pliers 1
D 1P-1861 Retaining Ring Pliers 1
E 248-3310 Spanner Wrench 1
F 1P-0510 Driver 1
Illustration 1 g02680056Note: Note the orientation of the lip seal, illustrated above, for installation.
Use Tooling (F) to install lip seal (14). Lubricate the lip with the lubricant that is being sealed.
Illustration 2 g02680020
Install bearing (13). Install lockwasher (12).
Install locknut (11). Use Tooling (E) to torque the locknut to 108 7 N m (80 5 lb ft). If necessary, increase the torque to align the slots.
Illustration 3 g02679882
Install shaft (9). Use Tooling (D) to install retaining ring (8).
Lubricate the bore for O-ring seal (10) with the lubricant that is being sealed. Install O-ring seal (10).
Illustration 4 g02679777
Install bearing (7) onto gear (5).
Use Tooling (C) to install retaining ring (6).
Illustration 5 g02679696
Install gear (5)
Install nut (4). Tighten nut (4) to a torque of 290 10 N m (214 7 lb ft). Tap the gear down with a hammer and torque nut (4) again to a torque of 290 10 N m (214 7 lb ft).
Illustration 6 g03676295
Measure the distance from the end of housing (15) to bearing (7). Dimension (X) is 6.6 0.5 mm (0.26 0.02 inch).
Illustration 7 g02681817
Install pulley (3).
Install studs (2). Tighten studs (2) to a torque of 30 5 N m (22 4 lb ft).
Install the washers and install nuts (1). Tighten nuts (1) to a torque of 47 9 N m (35 7 lb ft). End By:
Install the auxiliary drive.