AVSPARE.COM
parts catalog

HOUSING A HYD 5P2992 - Caterpillar


5P2992 HOUSING A HYD Caterpillar parts
Rating:
36
Alternative (cross code) number:
CA5P2992
5P-2992
5P2992
Caterpillar 5P2992 HOUSING A HYD
Weight: 13 pounds 6 kg.

Buy HOUSING A HYD 5P2992 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Do not disconnect the air line to the parking brake rotochamber until the air pressure is zero. Failure to do so can result in personal injury.
1. Disconnect air line (1) from the parking brake rotochamber. Connect shop air to the rotochamber and release the parking brake. 2. Remove cotter pin that holds pin (5) to the lever and rod end. Remove pin (5).3. Remove nuts (3) and the parking brake rotochamber from its mounting bracket.4. The steps that follow are for assembly purposes.5. Put parking brake rotochamber (2) in position on bracket. Do not tighten the nuts.6. Connect shop air to the parking brake rotochamber. Install the pin that holds rod end (4) to lever (6). Install the cotter pin in pin (5).7. Tighten the nuts that hold the rotochamber to the bracket. Remove the shop air.8. Connect air line (1) to the rotochamber.Disassemble And Assemble Parking Brake Rotochamber
Start By:a. remove parking brake rotochamber 1. Remove regulator (1) and yoke (2) from rod.
The rotochamber is under spring tension. Do not remove bolts (3) until assembly is under compression. If cover is removed without tooling (A), personal injury can result.
2. Install tooling (A) on the rotochamber assembly. Also, put wire around assembly as shown to help keep assembly in alignment during disassembly. 3. Remove bolts (3), cover (4), assembly (5), spring (6) and rod from body (7). The only replacement item in the rotochamber assembly is in the spring. If any other items are in need of repair, the entire unit must be replaced. 4. If necessary, remove the O-ring seal (8) and the felt wiper seal (9) from rod. 5. Install the felt wiper seal (9) and the O-ring seal (8) on the rod assembly (5). 6. Put rod assembly (5) in cover (4). Install spring (6) and body (7). 7. Put assembly in tooling (A) as shown.8. Put wire assembly around tooling (A) for alignment purposes and with the assembly in compression. Install the bolts to hold cover (4) on body (7). Remove tooling (A). 9. Install regulator (1) and yoke (2).End By:a. install parking brake rotochamber


Parts housing Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.