HOUSING AS 6C2624 - Caterpillar

Removal Procedure
Start By:
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct procedure.
Illustration 1 g01793474
Remove cover (1) .
Illustration 2 g01793494
Remove clamps (2). Remove cable assemblies (3). Reposition cable assemblies inside the engine compartment.
Illustration 3 g01787016
Remove panel (4). Remove cover (5) .
Illustration 4 g01793533
Remove tube assembly (6). Remove clips (7). Disconnect harness assembly (8). Remove belt (9). Refer to Operation and Maintenance Manual, "Belt Replace" for removal of belt (9). Remove bolts (11). Reposition refrigerant compressor (10) in order to access the water pump.
Illustration 5 g01768454
Remove bolts (12). Remove bracket (13) .
Illustration 6 g01768478
Remove hoses (14). Remove bolts (15). Remove water pump (16) .