HOUSING ASSEM. (R.H.) 6G0580 - Caterpillar

"Service Parameters"
The "System Parameters" submenu will display the ECM status of the system components. Some of the components may use multiple screens to display all the parameters that are monitored. The "System Parameters" submenu will sort all parameters into the following categories:
"Sort By ECM" allows the user to view the parameters that are associated with separate system components.
"Sort By Type" allows the user to view the parameters that are associated with separate units of measurement.
All parameters"Sort By ECM"The "Sort By ECM" submenu will sort all parameters into the following categories:
"Advisor": This selection will display the parameters for the Advisor monitoring system.
"Brake": This category will display the parameters that are monitored by the brake ECM.
"Chassis": This category will display the parameters that are monitored by the chassis ECM.
"Engine": This category will display the parameters that are monitored by the engine ECM.
"Transmission": This category will display the parameters that are monitored by the transmission ECM.
"VIMS": This category will display the parameters that are monitored by the VIMS ECM (payload)."Sort By Type"The "Sort By Type" submenu will sort all parameters into the following categories:
"Temperatures": This category will display the parameters that are monitored under the category of temperature.
"Pressures": This category will display the parameters that are monitored under the category of pressure.
"Speeds": This category will display the parameters that are monitored under the category of speed.
"Operator Inputs": This category will display the parameters that are monitored under the category of operator input.
"Machine Status": This category will display the parameters that are monitored under the category of "Machine Status".
"Totals": This category will display the parameters that are monitored under the category of totals."All Parameters"The "All Parameters" menu option allows the user to view the entire list of parameters."Calibrations"
The following selections are available through the "Calibrations" submenu:
"Truck Payload"Use the appropriate arrow button to highlight the desired calibration from the list. Then press the "OK" button. Follow the directions that are displayed on the screen to perform the calibration."System Tests"
The following selections are available through the "System Tests" submenu:
"Manual lube mode" (if equipped)
"Self test" (functional test)"System Information"
The "System Information" submenu will display details about the software version and details about the ECM module for the following systems:
"Advisor"
"Engine"
"Chassis"
"Transmission"
"Brake"
"VIMS Main"
"VIMS Analysis""Settings" Menu
Illustration 11 g01923777The "Settings" menu option is accessed from the "Home" menu. Press the up arrow button or the down arrow button until "Settings" is highlighted. Then press the "OK" button.Operating conditions, preferences of the operator and requirements for operating efficiency dictate the need to adjust the parameters.The "Display Setup", "Brake", "Chassis", "Transmission", and "VIMS" selections that are available in the "Setttings" menu can be password protected with the "Service Mode" password to limit access to programmable parameters. The programmed parameters in the password protected menu options are available for viewing only. Cat ET must be used to set the password.The following selections are available through the "Settings" menu:"Display Setup"
Individual preferences for the "Display Setup" need to be saved in the operator profile.If the profile is set to "Factory Set", the preferences will revert to the