HOUSING 6K5841 - Caterpillar

Illustration 10 g02460325
Diagnostics option is highlightedCodes and events contained in the "Diagnostics" option may be viewed at any time. But logged warning level 3 codes cannot be cleared until the "Service" mode is enabled.Warning level 1 and 2 codes can be cleared without enabling "Service"mode.
Illustration 11 g02460327
Diagnostics sub menuThe "Diagnostics" menu option will show a complete list of all active diagnostic and event codes, as well as all logged diagnostic and event codes.When the diagnostic message is acknowledged, a predetermined length of time passes before the message screen will appear on the monitoring system display again. This interval is dependent upon the severity of the warning level. Consult the appropriate warning category for the proper instruction.
Illustration 12 g02460356
Diagnostic message screenPress the "OK" button (2) while you are in the "Diagnostics" menu option to display the diagnostic message screen.Each line that is listed contains the following information about that event or that code.Description (10) - Description of diagnostic code identifier or event code identifier.Fault Description (11) - Failure mode description for diagnostics or system status for events.System Name (12) - Name of the system that is reporting the diagnostic or eventCode (13) - Component identifier and failure mode identifier for diagnostics or event identifier for events.Calibrations
Illustration 13 g02460818
Calibrations MenuThe "Calibrations" menu option is always available. The calibration procedures available on the display may vary depending on installed systems. Refer to Illustration 13 for the calibration options that are available.ECM Summary
Illustration 14 g02460859
The "ECM Summary" menu option allows the user to display a list of all electronic control modules along with associated part numbers on the machine.Password Entry Screen
The following Configurations are password protected under the "Service"mode:
Payload Weigh Range Configuration
Payload Maximum Velocity Configuration
Payload Lift Speed Skew Limit Configuration
Payload Lift Cylinder Rod End Pressure Sensor Configuration
Engine Idle Shutdown Enable Status
Engine Idle Shutdown Delay Time
Raise Kickout Enable
Lower Kickout Enable
Rack Kickout Enable
Dump Kickout Enable
Payload Weigh Range Configuration
Maximum Velocity Configuration
Payload Lift Speed Skew Limit Configuration
Payload Lift Cylinder Rod End Pressure Sensor
Payload Control System Calibration WeightThe first password protected feature you try to access after the keyswitch is in ON position will prompt you to enter the service password.Note: Once "Service" mode is active, you will not be prompted to enter the password again to access other password protected features. The Service mode is active until the machine is powered down. Upon the next start, the password must be re-entered to enable the Service mode.Service Password
The "Service Password" can be a number between 0 to 65535.Note: As the publish date of this manual, the default password is set to "1234_". The fifth position (_), must be a blank space. To view or change the password, connect to Caterpillar Electronic Technician (Cat ET) and navigate to the configurations section for the message display.Machine Status
Illustration 15 g02460880
The "Machine Status" menu option allows the operator or the technician to perform the real-time monitoring of electrical components in the machines major systems.From the Main Menu, use the "Four Way" button (1) to highlight the "Machine Status". Then, press the "OK" button (2) to access the