HOUSING & REGULATOR GP 8N0888 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: For information on reusability of the camshaft, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8097, "Camshaft Measurement", Guideline For Reusable Parts And Salvage Operations, SEBF8146, "Visual Inspection of Camshafts", and Guideline For Reusable Parts And Salvage Operations, SEBF8251, "Specifications for Measurement of Camshafts in 3114/3116 Engines". For information on reusability of the camshaft gear, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8045, "Timing Gears for All Engines".
Lubricate the camshaft and the camshaft bearings with clean engine oil.
Illustration 1 g00654762
Carefully install camshaft (4) and camshaft gear (1) in the engine.
When installing the camshaft, make sure the number one cylinder is at top center of the compression stroke with the timing bolt installed in the flywheel. The camshaft timing is very important. The timing mark on the camshaft drive gear must line up with the timing mark on the idler gear. Refer to the Specifications Manual for more information.
Illustration 2 g00677700
Typical example
Ensure that timing mark (5) on the camshaft gear is aligned with timing mark (6) on the idler gear.
Install camshaft retainer plate (2) and bolts (3). End By:
Install the front cover. Refer to Disassembly and Assembly, "Front Cover - Install".
Install the side cover. Refer to Disassembly and Assembly, "Lifter Group - Remove and Install".
Install the Unit Injector Hydraulic Pump. Refer to Disassembly and Assembly, "Unit Injector Hydraulic Pump - Install".
Install the Rocker Shaft and Pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".