HOUSING AS-PUMP 8N1569 - Caterpillar

Electric Power GenerationC2.2 GEN SET (S/N: JK71-339; JK81-128)Generator SetXQ60 (S/N: CF61-275; CF91-141)Introduction
Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.This Special Instruction describes the rework procedure for new voltage selector switch cable routing and cable repair.Safety Section
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Failure to follow all safety guidelines prescribed in this document and by governing authorities and regulatory agencies may result in severe injury or death of personnel or machine damage.
Personal injury or death can result from improper maintenance procedures. To avoid injury or death, follow the procedures exactly as stated below.
Before servicing/performing maintenance on the machine, electrical power must be physically disconnected; battery plugs must be disconnected from the batteries, or the trailing cable must be unplugged, and warning tags and padlocks shall be applied by a certified electrician. Certified electricians shall perform or direct any electrical work, including any energized testing, repair work in controllers, motors, or other approved compartments, and shall insure that all compartments are properly closed and inspected prior to re-energization. All applicable lock out and tag out procedures must be followed.
Required Parts
Table 1
Quantity New Part Number Part Name
50 cm (20 inch) 160-2249 Abrasion Sleeve
100 cm (39.5 inch) 356-0195 Abrasion Sleeve
11 cm (4.5 inch) 3E-6600 Seal
1097 cm (432 inch) N/A THOMAS & BETTS CO TBFT201-36