HOUSING 8S6196 - Caterpillar

9. Connect speed control cable assembly (12) to the rack on the transmission control.10. Put the transmission control lever in the "NEUTRAL" position. Connect direction control cable assembly (11) to the bellcrank on the transmission control. Make an adjustment to the transmission control linkage. See TRANSMISSION CONTROL LINKAGE ADJUSTMENTS in POWER SHIFT TRANSMISSION TESTING AND ADJUSTING Form No. SENR7756. 11. Make an adjustment to plastic collar (13) on the transmission selector lever, so the arrow shows "FIRST" speed when the selector lever is in the "FIRST" speed position.12. Put the parking brake cable in position in the steering column housing. 13. Install nut (14) that holds the cable.14. Install the locknut and knob (15) on the parking brake cable. 15. Slide boot (17) to the bottom of the steering column.16. Install shrouds (16) and (18). 17. Put plates (19) and (20) in position over the boot. Install the bolts that hold the plates and boot to the floor plate.Disassemble Adjustable Steering Column
start by:a) remove adjustable steering column 1. Remove three screws (1). Remove cover (2) from the steering wheel.2. Remove the nut from the steering shaft. 3. Remove steering wheel (3) with tooling (A) as shown. 4. Remove two nuts (5) from the shaft. Remove bracket assembly (4) from the steering column. 5. Remove two screws (6). Remove steering column tilt lock (7) from the bracket. 6. Remove dowels (8) with a hammer and punch.7. Remove lever (9), boss (11), spring and shaft (12) from support (10). 8. Remove four bolts (14). Remove plate (13), bolt and nut.9. Remove column assembly (15) from the housing. 10. Remove four bolts (17). Remove cap assembly (18) from housing (16). 11. Remove lever assembly (19) from the cap assembly. 12. Twist handle (20) and remove rack (21) from the lever assembly. 13. Remove screw (22) and remove handle (20) from the shaft.14. Loosen setscrew and remove collar (23). 15. Remove retainer ring (25). Remove retainer (26), spacer and shaft (24) from the lever. 16. Remove seal (27) and two bushings from the lever assembly. 17. Remove setscrew (28). Remove spring and detent ball from under the setscrew.18. Remove retainer ring (30). Remove pin (31) and knob from the cap assembly.19. Remove knob (29) and locknut from the pin. 20. Remove retainer ring (33). Remove tube assembly (32) and bearing from the cap. 21. Remove retainer ring (34) from the tube assembly. 22. Use tooling (B) to remove bearing (35) from the tube assembly. 23. Remove seal (36) from the cap. 24. Loosen setscrews (40). Remove bellcrank and pin (38) from the housing.25. Loosen setscrew (39). Remove pin, gear assembly (37) and four washers. 26. Remove bearing (41) from the gear.Assemble Adjustable Steering Column
1. Use tooling (A) to install the bearing in gear (1) even with the surface of the gear. 2. Install gear assembly (3), washers and pin in the housing. Tighten setscrew (5).3. Install bellcrank and pin (2). Tighten setscrews (4). 4. Use tooling (A) to install the lip seal