HOUSING-AXLE 8X2968 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock.
Retain the hydraulic tank oil.
Pressurized System!Hydraulic accumulators contain gas and oil under high pressure. DO NOT disconnect lines or disassemble any component of a pressurized accumulator. All gas pre-charge must be removed from the accumulator as instructed by the service manual before servicing or disposing of the accumulator or any accumulator component.Failure to follow the instructions and warnings could result in personal injury or death.Only use dry nitrogen gas to recharge accumulators. See your Cat dealer for special equipment and detailed information for accumulator service and charging.
Move the disconnect switch to the OFF position.
Illustration 1 g03336811
Disconnect hose assembly (1).
Illustration 2 g03336814
Loosen jamb nut (2).
Illustration 3 g03336829
Loosen clamp (3) and remove bolt (4).
Illustration 4 g03336858
Remove ride control accumulator (5).
Illustration 5 g03336872
Loosen jamb nut (6).
Illustration 6 g03336896
Loosen clamp (7) and remove bolt (8).
Illustration 7 g03336906
Remove ride control accumulator (9).
Illustration 8 g03336911
Remove bolts (10).
Illustration 9 g03336919
Disconnect harness clip (13). Remove bolts (11) and remove bracket assembly (12).
Illustration 10 g03336929Note: Mark the orientation of fitting (14) for assembly purposes.
Remove fitting (14) and the O-ring seal. Remove fittings (15) and the O-ring seals. Remove bolts (17) and remove manifold (16).
Illustration 11 g03336941
Remove clamps (18).
Illustration 12 g03336945
Remove cap (19).
Illustration 13 g03336947
Remove O-ring seal (20) from cap (19).
Repeat Steps 13 and 14 for the remaining ride control accumulator.
Discharge the ride control accumulator. Refer to Special Instruction, "Accumulator Discharging and Charging Procedures" for the proper procedure.Installation Procedure
Install ride control accumulators (5) and (9) in the reverse order of removal.