HOUSING AS-TANDEM DRIVE 8X3407 - Caterpillar

Use Tooling (D) to remove bearing (15) (not shown). Repeat this step for the opposite end of lift link (6).Installation Procedure
Illustration 16 g03383135
Illustration 17 g03383505
Lower the temperature of bearings (15).
Use Tooling (D) to install bearing (15) (not shown). Bearing (15) must be installed to a depth of Dimension (X). Dimension (X) is equal to 10.0 1.0 mm (0.39 0.04 inch). Repeat this step for the opposite end of lift link (6).
Apply Tooling (F) to the inside surface of bearings (15).
Illustration 18 g03383081
Apply Tooling (F) to lip seals (14). Use Tooling (E) to install lip seals (14). Repeat this step for the opposite end of lift link (6).
Illustration 19 g03383115
Install clamp (13) and tube assembly (12).
Illustration 20 g03383103
Install tube assembly (10). Install clip (11).
Illustration 21 g03383076
Typical Example
Attach a suitable lifting device to tilt link (6). The weight of tilt link (6) is approximately 64 kg (140 lb). Use the suitable lifting device to position tilt link (6) to the machine.
Install pin assembly (7).
Illustration 22 g03383525
Typical Example
Install pin assembly (8) into tilt lever (9).
Steps 10.a through 10.h are for machines that have the quick coupler attached.
Apply Tooling (F) to all pin assembly bores.
Illustration 23 g03382948
Attach a suitable lifting device to tilt link (6). The weight of tilt link (6) is approximately 64 kg (140 lb). Use the suitable lifting device to position tilt link (6) to the machine.
Illustration 24 g03383525
Typical Example
Install pin assembly (8) into tilt lever (9).
Illustration 25 g03382922
Install pin assembly (7).
Illustration 26 g03382876
Connect hose assemblies (5).
Illustration 27 g03382405
Position cylinder (4) and install pins (3).
Illustration 28 g03382382
Connect hose assemblies (2).
Illustration 29 g03382842
Raise quick coupler (1) and remove Tooling (A).End By:
Disconnect the steering frame lock.