HOUSING-PLUG 9G4349 - Caterpillar

Illustration 14 g03145062
Connect hose assembly (19). Install tube assembly (18).
Illustration 15 g03145060
Tighten clamps (17) to tube assembly (18).
Illustration 16 g03145058
Connect hose assembly (16).
Illustration 17 g03145057
Connect hose assembly (15).
Illustration 18 g03145037
Connect hose assemblies (14).
Illustration 19 g03144995
Connect hose assembly (13).
Illustration 20 g03144978
Connect hose assemblies (12).
Illustration 21 g03144957
Connect hose assembly (11). Install clip (10).
Illustration 22 g03147058
Connect hose assembly (9).
Illustration 23 g03144896
Install hose assembly (8). Connect hose assemblies (7) and hose assemblies (5). Install clip (6).
Illustration 24 g03144878
Close doors (4).
Illustration 25 g03144858
Illustration 26 g03144837Note: Make sure that the bearing cap and yoke mounting face are clean prior to assembly.
Use Tooling (A) in order to raise drive shaft (2) into position. Completely seat the U-joint by installing bolts (3). Tighten bolts (3) in an "X" pattern.
Remove bolts (3). Install new bolts (3). Tighten new bolts (3) in an "X" pattern to a torque of 520 70 N m (380 52 lb ft).
Illustration 27 g03144743
Remove Tooling (A).
Illustration 28 g03144716
Install bolt (1). Tighten bolt (1) to a torque of 900 100 N m (660 75 lb ft)
Illustration 29 g03146237
Lower the rear of the machine off the suitable cribbing. End By:
Install the secondary steering pump.
Install the rear axle oil cooler pump and motor assembly.
Install the input drive shaft.
Install the rear drive shaft.