HOUSING 9T4684 - Caterpillar

Customer specified parameters allow the engine to be configured to the exact needs of the application.Customer parameters may be changed repeatedly as operational requirements change.The following information is a brief description of the customer specified parameters. The following parameter values are included with the descriptions:
Minimum
Maximum
DefaultECM Identification Parameter
Equipment ID
"Equipment ID" is the identification of the equipment that is assigned by the customer. The "Equipment ID" is only for reference by the customer. The "Equipment ID" is not required by the Electronic Control Module (ECM).
Table 1
Value    Default    
17 digits
The available characters are dependent on the service tool that is being used.     Not programmed    Engine Rating Parameter
Rating Number
The rating number is the selected rating within a power rating family. The flash file defines the power rating family. The flash file can contain one to four ratings. The rating number defines the power rating that is used within the power rating family.
Table 2
Minimum    Maximum    Default    
1     7     1    Engine Idle Shutdown
The Engine Idle Shutdown parameters define the engine response when the isolator switch is turned to the OFF position.Minimum Ambient Air Temperature
Table 3
Value    Default    
0 to 29 Degrees C     0 Degrees C    Maximum Ambient Air Temperature
Table 4
Value    Default    
30 to 100 Degrees C     30 Degrees C    Shutdown Enable Status
Table 5
Value    Default    
Enabled
Disabled     Disabled    Shutdown Delay Time
Table 6
Value    Default    
1 to 60 minutes     5 minutes    Ambient Temperature Override Enable Status
Table 7
Value    Default    
Enabled
Disabled     Disabled    Multiple Engines on J1939
Engine Location
In a situation where multiple engines communicate on one J1939 channel, the Engine Location parameter defines the identity of each engine in the set.
Table 8
Value    Default    
Engine #1
Engine #2
Engine #3
Engine #4
Engine #5     Engine #1    Miscellaneous
Monitoring Mode Shutdowns
The "Monitoring Mode Shutdowns" parameter controls the shutdown feature that is associated with the engine monitoring feature. When this feature is enabled and a diagnostic code with a "-31" suffix is detected, the engine may be shut down.
Table 9
Value    Default    
Disabled
Enabled     Disabled    Monitoring Mode Derates
The "Monitoring Mode Derates" parameter controls the amount of derate that is associated with the engine monitoring feature. When this feature is enabled and a diagnostic code with an appropriate FMI is detected, the engine will be derated.
Table 10
Value    Default    
Disabled
Enabled     Enabled    Engine Acceleration Rate
The "Engine Acceleration Rate" parameter is the acceleration rate for the engine under normal operating conditions. A setting of "0" disables this function.
Table 11
Minimum    Maximum    Default    
0 rpm     65503 rpm/sec     0 rpm/sec    Engine Speed Decelerating Ramp Rate
The "Engine Speed Decelerating Ramp Rate" parameter is the deceleration ramp rate for the engine under normal operating conditions. A setting of "0" disables this function.
Table 12
Minimum    Maximum    Default    
0 rpm     65503 rpm/sec     0 rpm/sec    Configurable Inputs
Coolant Level Switch
A coolant level sensor is an optional switch input. Programming the "Coolant Level