HOUSING-AXLE SHAFT 9U2790 - Caterpillar

9U2790 HOUSING-AXLE SHAFT Caterpillar parts 815F, 815F II, 970F

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA9U2790
9U-2790
9U2790

Weight: 337 pounds 152 kg.

Buy HOUSING-AXLE SHAFT 9U2790 Caterpillar genuine, new aftermarket tractor parts with delivery
SOIL COMPACTOR, WHEEL LOADER,

Compatible equipment models: 9U2790:

SOIL COMPACTOR 815F 815F II

WHEEL LOADER 970F Caterpillar

Number on catalog scheme: 9

Caterpillar 9U2790 Parts scheme HOUSING-AXLE SHAFT

For full view, you need register

Information:

Illustration 1 g00334238
Parking Brake Lever in the DISENGAGED Position (1) Parking brake lever. (2) Release lever for the parking brake lock.
Place the parking brake in the DISENGAGED position. Depress the release lever (2) and push the parking brake lever (1) downward.
Illustration 2 g00335040
Parking Brake Control (1) Parking brake lever. (2) Release lever for the parking brake lock. (3) Fine adjustment knob. (4) Setscrew. (5) Brake disc. (6) Nut. (7) Nut.
Loosen nut (6) and nut (7) .
Tighten nut (7) to 12 2 N m (8.9 1.5 lb ft).
Turn nut (7) counterclockwise for one full turn. Verify that the brake disc (5) rotates freely.
Tighten nut (6) against nut (7). Tighten nut (6) to 67.5 7.5 N m (50 6 lb ft).
Remove the chocks from the wheels.Note: Test the brakes on a dry, level surface.
Check the area around the machine. Make sure that the machine is clear of personnel and clear of obstacles.
Fasten the seat belt before you test the brakes.
If the machine is equipped with All Wheel Drive, place the machine in Two-Wheel Drive.
Illustration 3 g00309744
Parking Brake Lever in the Engaged Position (1) Parking brake lever. (2) Release lever for the parking brake lock.
Engage the parking brake. Pull the parking brake lever (1) upward in order to engage the parking brake.
Start the engine. Raise the bucket slightly.Note: If the machine is equipped with a standard transmission, perform step 13. If the machine is equipped with a power shift transmission, perform step 14.
Perform the parking brake test and adjust for machines that are equipped with a standard transmission.
Place the transmission speed control lever in the THIRD SPEED position.
If the machine begins to move, reduce the engine speed immediately and apply the service brake pedal.
Place the transmission direction control lever in the FORWARD position. An audible alarm will sound and the alert indicator will light.
Gradually increase the engine speed to high idle. The machine should not move.Note: If the machine moves perform steps 13.d through 13.j. If the machine does not move, proceed to step 15.
Place the transmission direction control lever in the NEUTRAL position.
Lower the bucket to the ground