HSG-CLUTCH-YM 3857196 - Caterpillar

Illustration 40 g00628766
Install guard (53) to the tilt cylinder with three washers (54) and with three bolts (55). Tighten bolts (55) to a torque of 120 20 N m (90 15 lb ft).
Install bracket (57) to guard (53) and to the tilt cylinder with washer (54) and with bolt (55). Tighten bolt (55) to a torque of 120 20 N m (90 15 lb ft).
Install grommet (58) to hose (51). Assemble these components: clip (59), clip (60), grommet (58), bracket (57), washer (54) and bolt (55). Tighten bolt (55) to a torque of 120 20 N m (90 15 lb ft).
Illustration 41 g00628752
Remove the covers from the manifold on the radiator guard. Use these components to connect hoses (42) and (43) to the manifold on the radiator guard: two O-ring seals (39), four flanges, eight washers and eight bolts. Tighten the bolts to a torque of 50 10 N m (37 7 lb ft). The items that are not numbered are part of the tilt cylinder lines.
Check the oil in the hydraulic tank. Add oil, if necessary. Cycle the cylinders through several full strokes in both directions in order to purge air from the lines and from the cylinders. Refill the hydraulic tank to the full mark.
Illustration 42 g00479754
(H) 25 to 45 mm (1.0 to 1.8 inch)
An improperly adjusted brace causes binding between the surface of pivot pin (6) and the surface of the bracket on the bulldozer blade. Check clearance (H) between pivot pin (6) and C-frame (7). If clearance (H) is not in the 25 to 45 mm (1.0 to 1.8 inch) range, then adjust the push arms (21) on both sides of the machine. See Illustration 42.
After you have completed this procedure, prepare the machine for operation. Refer to your machine's Operation and Maintenance Manual for instructions.Standard Torque for Fasteners
Table 14
Nuts and Bolts    
Thread Size    Standard Torque (1)    
Metric    Inch    
M6        
12 3 N m (9 2 lb ft)    
    1/4    
12 3 N m (9 2 lb ft)    
    5/16    
25 6 N m (18 4 lb ft)    
M8        
28 7 N m (21 5 lb ft)    
    3/8    
47 9 N m (35 7 lb ft)    
M10        
55 10 N m (41 7 lb ft)    
    7/16    
70 15 N m (50 11 lb ft)    
M12        
100 20 N m (75 15 lb ft)    
    1/2    
105 20 N m (75 15 lb ft)    
M14        
160 30 N m (120 22 lb ft)    
    9/16    
160 30 N m (120 22 lb ft)    
    5/8    
215 40 N m (160 30 lb ft)    
M16