AVSPARE.COM
parts catalog

HUB L.H. 0004128 - Caterpillar



0004128 HUB L.H. Caterpillar parts WE-601B HUB
Rating:
69
Alternative (cross code) number:
CA0004128
000-4128
0004128
Caterpillar 0004128 HUB L.H.

Buy HUB L.H. 0004128 Caterpillar genuine, new aftermarket tractor parts with delivery
WINDROW ELEVATOR,

Compatible equipment models: 0004128:

WINDROW ELEVATOR  WE-601B   Caterpillar
Number on catalog scheme: 28
  
  For full view, you need register

Information:

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 425-0952 Chock 2
B 504-9792 Lift Gp 2
C 5P-7311 Chain Puller 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01389657
Use a suitable lifting device to install drive chain (10). The weight of drive chain (10) is approximately 40 kg (90 lb).
Illustration 2 g01389655
Use Tooling (C) to connect master link (9). Install cotter pins (8). Note: The links should not be in adjacent tooth spaces on the sprocket when the links pass on the center sprocket, or interference may result.
Illustration 3 g01389312
Install a new gasket (7), cover (6), and bolts (5). Tighten bolts (5) to a torque of 27 7 N m (20 5 lb ft). Install a new gasket (4), cover (3), and bolts (2). Tighten bolts (2) to a torque of 27 7 N m (20 5 lb ft).
Illustration 4 g01389308
Install walkways (1).
Illustration 5 g06275129
Typical example
Illustration 6 g06275133
Typical example
Use Tooling (B) to lower the rear of the machine. Remove Tooling (B). Refer to Tool Operating Manual , NEHS1303 for more information on Tooling (B).
Illustration 7 g01389301
Remove Tooling (A) from the front wheels.
Fill the tandem housing with oil. Refer to Operation and Maintenance Manual, "Tandem Drive Oil - Change". End By:
Install the drive shaft.

Caterpillar parts catalog:

Caterpillar parts catalog
WE-601B WINDROW ELEVATOR 7EC00168-UP (MACHINE)


Parts hub Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.