HUB 1719066 - Caterpillar

1719066 HUB Caterpillar parts 318C, 319C, 320C, 323D L, 323D LN

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1719066
171-9066
1719066

Weight: 5 pounds 2 kg.

Buy HUB 1719066 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Show more prices Caterpillar parts

Compatible equipment models: 1719066:

EXCAVATOR 318C 319C 320C 323D L 323D LN Caterpillar

Number on catalog scheme: 5

For full view, you need register

Information:

When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Illustration 5 g00932574 (A) Dimension from the face to the bearing ... 7.80 .50 mm (0.307 0.020 inch) (B) Dimension from the face to the bearing ... 7.40 0.50 mm (0.2913 0.0197 inch) (1) Use a 46 mm socket in order to remove the bolt. (2) Lubricate sealing lips with a thin covering of the lubricant that is being sealed. (3) Apply Tooling (D) to the seal groove prior to assembling the wiper seal. (4) Torque for head ... 600 130 N m (440 95 lb ft)Note: Lubricate the threads with Tooling (E).Installation Procedure
Table 3
Required Tools
Tool Part Number Part Description Qty
A 311-1362 Vacuum Cap 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 6 g01346803
Use a suitable lifting device in order to position wheel lean cylinder (3). The weight of wheel lean cylinder (3) is approximately 32 kg (70 lb).
Install retainer (8) and bolt (7). Note: The gap between the rod end of wheel lean cylinder (3) and retainer (8) must be 0.76 mm (0.030 inch).
Lower the head end of wheel lean cylinder (3) downward. Install pin (6).
Install retention plate (5) and bolts (4).
Illustration 7 g01346799
Connect hose assemblies (2).
Illustration 8 g01346798
Remove the wheel lean bolt and nut (1).
Illustration 9 g01368952
Remove Tooling (A).
Check the hydraulic oil level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".