HUB 2895885 - Caterpillar

Illustration 5 g01086233
Front view (8) J18/P18 connectors for the harness to the terminal box for the master ECM
Thoroughly inspect each of the following connectors:
Master ECM J1/P1 connectors
J9, J5/P5, J8/P8 and J10/P10 connectors on the terminal box for the master ECM
J3/P3 connectors for the slave ECM
J11/P11 connectors on the terminal box for the slave ECM
J18/P18 connectors for the ITSM
Check the torque of the allen head screw for the ECM connectors. The proper torque is 6 1 N m (53 9 lb in).
Illustration 6 g00994115
Harness side of the master ECM P1 connector (P1-8) Cat Data Link + (P1-9) Cat Data Link -
Illustration 7 g00994117
Harness side of the P3 connector for the slave ECM (P3-8) Cat Data Link + (P3-9) Cat Data Link - (P3-29) Harness code (P3-60) harness code
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the circuit for the Cat Data Link.
Check the harness and wiring for abrasion and for pinch points from the slave ECM to the master ECM.
Check the wiring harness from the P10 connector to the optional remote control panel.Expected Result:The connectors, pins, and sockets are connected properly. The connectors and the wiring do not have corrosion, abrasion, or pinch points.Results:
OK - The components are in good condition with proper connections. Proceed to Test Step 2.
Not OK - The components are not in good condition and/or at least one connection is improper.Repair: Perform the necessary repairs and/or replace parts, if necessary. Stop.Test Step 2. Check the Cat Data Link
Verify that the engine control is in the OFF/RESET mode. Verify that the electrical power is removed from the engine.
Connect Cat ET to the service tool connector. Refer to Troubleshooting, "Electronic Service Tools".
Set the engine control to the STOP mode. Restore the electrical power to the engine.
Select the "File/Select ECM" menu on the Cat ET. Verify that all of the modules are displayed on the "ECM Selector" screen.Verify that the following diagnostic codes are not activated.
0590-09 Unable to communicate with Engine ECM
1636-09 Loss of communication with Engine #2 (Slave)
1042-09 Unable to communicate with ITSMNote: If Cat ET displays "Duplicate Type on data link. Unable to Service", there may be a problem with the harness inside the terminal box for the slave ECM. Set the engine control to the OFF/RESET mode. Remove the electrical power from the engine. Check the continuity between terminals J3-29 and J3-60. Verify that the jumper wire is in good condition. Make repairs, as needed.Expected Result:All of the modules are displayed on the "ECM Selector" screen. There are no active diagnostic codes for the Cat Data Link.Results:
OK - All of the modules are displayed on the "ECM Selector" screen. There are no active diagnostic codes for the Cat Data Link. The problem seems to be resolved.Repair: If any of the above codes are logged and the engine is not running properly, refer to Troubleshooting, "Troubleshooting Without a Diagnostic Code".If any of the above codes are logged and the engine is running properly, there may be an intermittent