HUB 3P0100 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Drain the coolant from the cooling system to a level below the coolant temperature sensor into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Illustration 1 g06319444
Disconnect harness assembly (1).
Illustration 2 g06319448
Remove coolant temperature sensor (2).
Illustration 3 g06319467
Remove O-ring seal (3).Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 4 g06319467
Install O-ring seal (3).
Illustration 5 g06319448
Install coolant temperature sensor (2) and tighten to a torque of 20 3 N m (15 2 lb ft).
Illustration 6 g06319444
Connect harness assembly (1).
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".