HUB FAN 7E8637 - Caterpillar

Table 1
Required Parts List    
Item     Qty     Part Number     Description    
1     2     354-7988     Retainers    
2     24     9X-8268     Washers    
3     24     8T-0357     Bolts    Use the following procedure to update each rear wheel group with the new 354-7988 Retainer :
Permit only one operator on the machine. Either keep other personnel away from the machine, or keep other personnel in the sight of the operator.
Move the machine to a smooth horizontal location. Move away from any machines that are working and any personnel.
Move the transmission control to the PARK position.
Activate the parking brakes. Stop the engine and remove the ignition key.
Turn the battery disconnect switch to OFF position.
Place blocks in front of the wheels and behind the wheels.
Personal injury or death can result from machine movement.Place blocks in front of and behind the wheels to make sure the machine does not move while the parking brakes are disengaged.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hot oil or hot components.At operating temperature, oil is hot and under pressure. Hot oil can cause burns.Remove the fill cap only when the engine is stopped, and the fill cap is cool enough to touch with your bare hand.Do not allow hot oil or components to contact skin.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g02198853
Rear wheel group with former 208-8797 Retainer (5)
Remove the final drive group (6). Refer to Disassembly and Assembly, RENR8304, "777F Off-Highway Truck Power Train", "Final Drive - Remove".
Remove the 12 bolts (3) and remove former retainer (5) and shim pack (4). Discard the bolts and the retainer. Save the shim pack.
Illustration 2 g02191793
Rear wheel group with new 354-7988 Retainer (1) Note: Wheel bearing preload does not require adjustment.
Reinstall the shim pack (4) that was removed in Step 8.Note: Apply red Loctite 271 to the threads of the 12 new bolts (3) .
Assemble the new retainer (1) to the spindle by using 12 new bolts (3) and 12 new washers (2) .
Tighten the bolts (3) to a torque of 125 20 N m (92 15 lb ft). Again, tighten the bolts to a torque of 270 40 N m (199 30 lb ft).
Assemble the final drive group (6) that was removed in Step 7. Refer to Disassembly and Assembly, RENR8304, "777F Off-Highway Truck Power Train", "Final Drive - Install".