HUB-IMPELLER 7G5671 - Caterpillar

Removal Procedure
Start By:
Remove the alternator, if necessary. Refer to Disassembly and Assembly, "Altenator - Remove and Install".
Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand.Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns.Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Remove the belt. Refer to Operation and Maintenance Manual, "Belts - Inspect/Replace".
Illustration 1 g01151111
Loosen hose clamps (1).
Disconnect hose (2).
Remove bolts (4), elbow assembly (5), and the gasket.
Remove bolts (6).
Remove water pump (3).