HUB ASSEM. 7K1311 - Caterpillar

Caterpillar Products All MachinesIntroduction
This Special Instruction provides instructions for installing the Remote Disable Module Kit. Once activated, the RDM will prevent the machine from being started from the key switch in the off position. The RDM will also allow an authorized person in a remote, off board location to enable a disabled machine to start. The RDM will not shutdown a running machine.The system consists of a module and wiring harness to allow connection to the machine key switch, ground, starter circuit, and J1939. The Remote Disable Module System is proposed for use on all machines, both Caterpillar and competitive brands, providing a fleet solution for equipment owners. This kit is offered as an after-market attachment.Note: It is important to read this entire Special Instruction before beginning the installation of the Remote Disable Module System.Note: This device is not to be used for "Power Lock and Tagged Out" procedures. Refer to section "Power Locked and Tagged Out" for instructions.
Illustration 1 g03879727
Remote disable module (RDM) kit
Important Safety Information
Do not perform any procedure in this special instruction until you have read this special instruction and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures can result in personal injury. The following procedures should also be observed.Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Ensure that any tool, procedure, work method, or operating technique you use that is not recommended by Caterpillar is safe. Ensure that the product will not be damaged or the product will be made unsafe by the operation, lubrication, maintenance, or the repair procedures that are used.
Personal injury or death can result from improper assembly procedures.Do not attempt any assembly until you have read and understand the assembly instructions.
Accidental engine starting can cause injury or death to personnel working on the equipment.To avoid accidental engine starting, disconnect the battery cable from the negative (−) battery terminal. Completely tape all metal surfaces of the disconnected battery cable end in order to prevent contact with other metal surfaces which could activate the engine electrical system.Place a Do Not Operate tag at the Start/Stop switch location to inform personnel that the equipment is being worked on.
Power Locked and Tagged Out
Insure that the engine has been disconnected/isolated from the power line and