HUB 9M8959 - Caterpillar

Illustration 8 g03408016When an object is detected in the stop zone, typically 2 m (6.56 ft) to 4 m (13.12 ft) away from the machine in the coverage area, all five segments will be shown as a solid red bar (F). The solid red bar (F) will blink one time per second. Refer to Illustration 8.Note: Refer to Table 2 in the "Audible Alarming" section for alarming details.Audible Alarming
The system will produce audible alarms when in the critical or stop zone and a reverse gear is selected. There are two Object Detection Alarm Modes, "Continuous" and "Discrete" that can be selected in the configuration page.Note: The alarm will only sound when there is an object in the direction of travel and the system is active. The system will enter standby if the standby mode conditions are met. No alarming or proximity alerts will occur in standby mode. For additional information on the alarming refer to Table 2.Continuous
The Object detection system will produce an audible alarm beginning in the caution level 3 zone. As the distance of the object decreases, the alarming frequency increases until a solid alarm is produced when the object enters the stop zone.
Table 1
Continuous Alarm Mode
Gear Detections Alarming Activation
Reverse Rear Audible alarm beginning in the Caution Level 3 Zone increasing in frequency until a solid alarm is produced when the object enters the Stop Zone. Alarm will continue until the Object Detection Sensors no longer detects an object, the alarm acknowledge check button is pressed, the system enters stand by mode, neutral gear is selected, or a directional gear change is made. Note: For Motor Graders, and Wheel Loaders, the system will only be active in reverse gear.Discrete
For the first critical zone detection in the direction of travel, the system will issue two short alarms (.5 seconds long with a .5 second break) and one solid alarm (1.5 second) in stop zones. After an audible alarm is produced because of detection on the rear, the system will NOT produce an audible alarm again if there is a new detection on the rear.
Table 2
Discrete Alarm Mode
Gear Detections Alarming Activation
Reverse Rear Alarm twice for one half second if object is detected in Critical Zone. Alarm once for 1.5 seconds again if object enters Stop Zone. After Stop Zone alarming, the audible alarm will be silenced until a gear change occurs or the system state changes. Note: For Motor Graders, and Wheel Loaders the system will only be active in reverse gear.Camera View
This function allows the operator to see objects around the machine to aid in object identification. The camera function is enabled whenever the system is powered up. The camera view is available in all machine states. The camera view will occupy approximately 90% of the main screen.System Information and Warning Display
This portion of the main screen has two functions. The first function is informing the operator of the status of the system. The status of the system can be active, standby, or faulted.Active
Illustration 9 g03408047The system is in