HUB 9W8384 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 4C-9832 Engine Rollover Stand 1 Start By:
Remove the rocker shaft assemblies and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Push Rods - Remove".
Remove the front drive housing. Refer to Disassembly and Assembly, "Front Drive Housing - Remove".
Remove the rear gear group. Refer to Disassembly and Assembly, "Gear Group (Rear) - Remove".
Remove the piston cooling jets. Refer to Disassembly and Assembly, "Piston Cooling Jets - Remove and Install".
The rocker shaft assemblies and the push rods must be removed to ensure that the inlet and exhaust valves are not open. If the valves are open the face of the inlet and exhaust valves could be damaged when the pistons are pushed into the cylinder, away from the crankshaft.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Use Tooling (A) to turn the engine in a horizontal position. The engine can also be supported with blocks. The G3516 Engine weigh approximately 6447 kg (14200 lb). Note: It is not necessary to remove the counterweights from the crankshaft, if the piston and connecting rod assemblies have been removed from the engine.
Illustration 1 g00577386
Place identification marks on counterweights (1). Remove counter