HYDRAULIC AR-PROPEL 1856140 - Caterpillar

Illustration 1 g00703283
The UPS shipping crateThe following procedure is used to remove the optional shipping crate.
Remove the screws that secure the lid of the crate.
Remove the lid of the crate.
Support the short sides of the crate.
Remove the bolts from corners of the crate.
Remove the short sides of the crate. The short sides of the crate receive forks.
Support the front of the crate.
Remove the bolts from the bottom of the front side of the crate.
Remove the front side of the crate. The front of the crate is marked "FRONT". The front and the rear of the crate are the long sides of the crate. Note: The long sides of the crate do not receive forks.
Support the rear side of the crate.
Remove the bolts from the bottom of the crate's rear side.
Remove the rear side of the crate. The rear of the crate is marked "REAR". The front and the rear of the crate are the long sides of the crate. Removal of the Shipping Skid
Illustration 2 g00703295
The UPS on skidsRefer to Illustration 3. Four 0.5 inch bolts (5) secure the system to the skids. The system must be lifted over these bolts in order to remove the skids. Lift the system with a fork lift or lift the system with a pallet jack. Wood blocks are fastened to the skid in order to distribute the weight evenly over the skids. These blocks are used in order to support the system.Using a Fork Lift
Illustration 3 g00777096
(1) Blocks (approximately 101.6 mm (4 inch) by 101.6 mm (4 inch)) (2) Skids (3) Plywood (4) Boards (approximately 25.4 mm (1 inch) by 101.6 mm (4 inch)) (5) Mounting Bolts and nutsIf a fork lift is used, the following procedure is used in order to remove the skids.
Remove the screws from the two boards (4) .
Remove two boards (4). These boards will be used later. Save these boards in a safe location.
Remove four nuts (5) from the four bolts that secure the system to two skids (2) .
Insert the forks from the right side of the system.
Lift the system slightly in order to remove the weight from the blocks.
Remove four blocks (1). These blocks will be used later. Save these blocks in a safe location.
Lower the system on the skids (2) .
Move the fork lift to the front of the system. Insert the forks between the steel channel cleats. This is the area that was occupied by the blocks (1) .
Test the placement of the forks. Lift the system enough to remove the weight from the two skids (2) .
If the system is securely balanced on the forks, proceed to Step 11. If the system is NOT securely balanced on the forks, reposition the fork lift.
Lift the system in order to clear the bolts.
Illustration 4 g00777101
(6) Mounting bolt (7) Channel cleat
Move the skids away from the system.
Remove the steel channel cleats from the system. While the steel channel cleats are being attached to the floor, use the wood blocks in order to support the