IDLER GP-FRONT 1132907 - Caterpillar

Remove & Install Oil Filter Base & Engine Oil Cooler (Industrial Engines)
1. Remove the coolant from the cooling system. 2. Loosen clamps (1) and disconnect hoses (2) from engine oil cooler (4). Remove oil filters (5).3. Remove two bolts (3) and two bolts from behind the oil cooler.4. Remove oil filter base and engine oil cooler as a unit. The following steps are for installation of the oil filter base and engine oil cooler.5. Inspect the O-ring seals in the oil filter base. Install new seals if needed. Put oil on the seals.6. Put the oil filter base and oil cooler in position on the engine. Install four bolts (3).7. Install two oil filters (5). Connect two hoses (2) and tighten clamps (1).8. Fill the cooling system to the correct level.Disassemble & Assemble Oil Filter Base & Engine Oil Cooler (Earlier Industrial Engines)
Start By:a. remove oil filter base & engine oil cooler 1. Remove the bolts that hold cover (1) to base (2). Remove the cover.2. Remove the three nuts that hold core (3) to the base. Remove the core. 3. Remove the cap and fitting (6), spring (5), and valve (4) from the base. The following steps are for assembly of the oil filter base and engine oil cooler.4. Put clean oil on valve (4) and spring (5). Install the valve, spring, fitting (6) and the cap in base (2). Tighten fitting (6) to a torque of