IDLER GP-FRONT 1941241 - Caterpillar

Table 1
Sensor     EIS Engines     Engines with an ECM    
Coolant Temperature     Yes     No    
Oil Pressure     Yes     No    
Coolant Loss     Yes     Yes    
Oil Temperature     No     Yes    The engine oil temperature sensor is optional. The engine coolant fluid level sensor is optional.The sensor power supply functions whenever power is applied to the GSC+.The GSC+ is usually programmed in the factory. The GSC+ handles a diagnostic code that is associated with the sensor power supply as an alarm fault. P004 = 0. If the GSC+ is programmed to shutdown, P004 is equal to 1 for a problem with the sensor power supply. It is not necessary to press the "Alarm Codes" key in order to view the CID 0269 FMI 04. The CID 0269 FMI 04 is automatically shown on the upper display.Diagnostic codes are created when the harness connector is disconnected from the GSC+ during these troubleshooting procedures. Clear these created diagnostic codes after the particular problem is corrected and the particular diagnostic code is cleared. The possible cause of a CID 0269 FMI 04 occurs when the voltage of the sensor supply is less than 7.5 DCV.Begin performing these procedures only when CID 0269 FMI 04 is active and the "DIAG" indicator is FLASHING on the upper display. The GSC+ treats a CID 0269 FMI 04 as an alarm fault. Active alarm faults are shown on the upper display when the "Alarm Codes" key is pressed and the engine control switch (ECS) is in any position except the OFF/RESET position. For an inactive diagnostic code, the problem may be intermittent. To troubleshoot an inactive diagnostic code, use the preceding system schematic and see Testing And Adjusting, "Electrical Connector - Inspect". Clear the diagnostic code from the fault log after the troubleshooting procedure is completed.Test Step 1. CHECK THE GSC+.
Turn the ECS to OFF/RESET.
Disconnect the harness from the GSC+.
Turn the ECS to