IDLER GP-FRONT 4891619 - Caterpillar

Table 1
Mode 5 Harness Code Display     Application    
03     Generator Engine (1) with Standby Panel    
05     Generator Engine (1) With Prime Panel    
06     Generator Engine (1) With Premium Panel And "SCAC"    
07     Generator Engine With Premium Panel And JWAC "JWAC"    
09     Marine Propulsion Engine With Premium Panel And "SCAC"    
10     Marine Propulsion Engine With Prime Panel And Marine Gear Sensors    
11     Marine Propulsion Engine With Prime Panel And No Marine Gear Sensors    
12     Marine Propulsion Engine With Premium Panel And "JWAC"    
35     Locomotive Engine    
( 1 ) Includes Marine AuxiliaryNote: If the selection for the harness code does not match the application, the Caterpillar Monitoring System may not operate correctly. The following list contains problems that the operator may encounter: the loss of event notification, incorrect data displays, incorrect gauge needle position and incorrect activation of diagnostic codes. CID 127 FMI 08, CID 177 FMI 08 and CID 819 FMI 02 are commonly caused by harness codes that are not correct for the application on new installations. Troubleshooting procedures are given for these diagnostic codes in the Testing And Adjusting Section of this Manual.An example of Harness Code Mode (Mode 5) is provided below.
Illustration 1 g00533697
Display Area