IDLER 7B5364 - Caterpillar

Illustration 1 g01344008
Note: Prior to assembling the differential, assemble the bevel gear to the housing. Ream one hole to a diameter of 19.050 0.013 mm (0.7500 0.0005 inch). Install one bolt into the reamed hole. Use the bevel gear as a guide in order to ream the remaining thirteen holes. Install bolts (1).
Illustration 2 g01344010
View A-A (1) Torque for the 14 bolts ... 440 40 N m (325 30 lb ft) (2) Height of installation of the two pins above the bore ... 7.6 mm (0.30 inch) (3) 9M-5874 Shim Pack thickness ... 3.30 mm (0.130 inch)Note: Apply 7M-7456 Compound to the threads of bolts (4) . (4) Torque for the ten bolts ... 135 20 N m (100 15 lb ft) (5) Interference of the pin ... 0.05 0.025 mm (0.0020 0.0010 inch) (6) Lubricate the bore with a small amount of the lubricant that is being sealed. (7) The mating surfaces between the gear and the differential must be free of paint. (8) Lubricate the bore with a small amount of the lubricant that is being sealed. (9) 6G-1881 Shim Quantity ... 8 Thickness ... 0.178 mm (0.0070 inch) 6G-1893 Shim Quantity ... 6 Thickness ... 0.127 mm (0.0050 inch) (10) Torque for the four bolts after gear adjustment ... 1100 150 N m (811 111 lb ft)