IMPELLER-CONVERTER 1T1051 - Caterpillar

The Mode Switches can be used to change the performance characteristics of the engine. The electronic service tool is used to program the characteristics. Select the "Service" drop-down menu and then select "Engine Operating Mode Configuration". A maximum of two switches can be used. "Switch 1" is connected to J1:39 Mode Switch 1. "Switch 2" is connected to J1:46 Mode Switch 2. The other contact on both switches is connected to J1:35 Switch Return.Number of Switch Inputs
This number is the total number of switches that will be used. The switches can be individual switches or a multiple rotary switch.
Table 1
Range    Default    
0 to 2     0    Mode Selection Number
This parameter is a non-programmable parameter that represents the number of possible combinations of switch positions. This parameter is based on the value that is programmed into the "Number of Switch Inputs" parameter.Mode Selection Switch Input 2 and Mode Selection Switch Input 1
The number of these non-programmable parameters that are visible depends on the value that is programmed into the "Number of Switch Inputs" parameter. "Open" signifies that the switch is in the OFF position. "Ground" signifies that the switch is in the ON position.Enabled
If "Yes" is selected, the ECM is programmed to use the values in "Rating Number", "Throttle 1 Droop Percentage", "Throttle 2 Droop Percentage" and "TSC1 Droop Percentage" for the given combination of switch positions.
Table 2
Values    Default    Factory Password    
Yes
No     No     Yes    Rating Number
This parameter is the engine rating that is used by the Electronic Control Module (ECM) for a given combination of switch positions. There is a maximum of four ratings in a flash file.
Table 3
Range    Default    Factory Password    
1 to the maximum number of ratings in the currently installed Flash File     1     No    Rated Speed (RPM)
This parameter represents the engine speed that is selected when the mode switch or the mode switches are in a particular position.
Table 4
Range    Default    Factory Password    
"Programmed Low Idle" to "Programmed High Idle"     5.0%     No    Throttle 1 Droop Percentage
This parameter represents the amount of droop that is applied to the "Throttle 1" input.
Table 5
Range    Default    Factory Password    
0 to 10 percent     5.0%     No    Throttle 2 Droop Percentage
This parameter represents the amount of droop that is applied to the "Throttle 2" input.
Table 6
Range    Default    Factory Password    
0 to 10 percent     5.0%     No    TSC1 Droop Percentage
This parameter represents the amount of droop that is applied to the "Torque Speed Control 1(TSC1)" input.
Table 7
Range    Default    Factory Password    
0 to 10 percent     5.0%     No