IMPELLER-PUMP 2W9727 - Caterpillar

Zero Cameras:
Camera cannot be accessed.
Camera Hotkey is hidden.
Camera is not shown during boot or in reverse.
One Camera:
Camera icon indicates single camera.
Camera Hotkey is shown.
Camera screen is shown while in reverse.
Two Cameras:
Camera icon indicates two cameras.
Camera Hotkey is used to toggle between two installed cameras.
Camera screen shows Camera 1 while in reverse. (Camera 1 will always be the reverse camera.)
Three Cameras:
Camera icon indicates three cameras.
Camera Hotkey is used to toggle between each camera input.
Camera screen shows Camera 1 while in reverse. (Camera 1 will always be the reverse camera.)Performance Pages
The Performance Pages are the main introductory pages on the SWL Display. Real-time machine status information can be monitored within the Performance pages. The SWL has five Performance pages. The Main Performance page will appear during the initial startup of the machine. Push the UP and DOWN directional arrow buttons to scroll through the pages.
Illustration 14 g03820390
Performance Page 1 (nighttime mode).
Illustration 15 g06017050
Performance Page 2 (daytime mode)
(10) Current Fuel Reading
(11) Current Job Reading
(12) Fuel Reset buttonCurrent Fuel
In the "Current Fuel" area of the Performance page, "15 Min" will constantly appear. The displayed time denotes the "Current Fuel" calculation based on a 15 minute average amount of time.Current Job
In the "Current Job" area of the page, "X Hours" will appear. These displayed hours equal the Service Meter Hours minus the hours since the operator last pressed the "Fuel Reset" button. If the Service Meter Hours is "30" and the operator presses the "Fuel Reset" button at "25" hours, "5" hours will appear on the Display. The value will increment each hour until the operator presses the "Fuel Reset" button. The number will then reset to "0" hours.The Gauges on a Performance page display the current value of a parameter within its possible range.
Illustration 16 g03820406
Performance Page 3.
Illustration 17 g03820411
Performance Page 4.
Illustration 18 g03820413
Performance Page 5.
Bottom Information Banner
Ambient Temperature
Illustration 19 g06017057
(13) Ambient TemperatureThe Ambient Temperature (13) appears in the bottom information banner on the Display.Service Hour Meter
Illustration 20 g06017081
(14) Service Hour MeterThe Service Hour Meter (14) appears in the bottom information banner on the Display.Pop-up Messages or Fault Alerts
Illustration 21 g06017094
(15) Snooze or Cancel SymbolWhen a machine alert or Fault occurs, a Pop-up Message will also appear in the bottom information banner. Reference the "Service Menu > Service: Diagnostics and Events" section and the "Pop-up Messages" section in this manual for more information.A "Snooze" or "Cancel" symbol (15) may appear on the right side of the Display when a Level 1 or 2 Pop-up Message or Fault is present in the bottom banner. The operator may press the button next to the symbol to cancel or temporarily "snooze" the message.Note: Level 3 (red) Messages or Faults cannot be snoozed. The snooze button will not appear on the right side of the Display during this event.