INCLINOMETER 3727101 - Caterpillar

LOADERS
950F II (8TK),
966F II (9YJ),
970F (9JK),
980F (3HK)Problem:
All above listed machines built in Gosselies are shipped with the CMS Control Speed Gauge set to Km/h.The speed gauge can be changed to MPH if so desired. Solution:
(Except 980F)Loosen the 4 Truss Head Screws holding the 8R9999 Housing and CMS Control to the 106-0623 Dash.Reach behind the GMS Control to access the Unit Connector that is attached to two black wires Nos. 292 and 201. Remove the 6W8944 Receptacle at the connector end.Rework the 6W8944 Receptacle by removing the jumper wire and replacing the 7N7779 Socket and 7N7780 Pin with two 9G3695 Plugs.Install the reworked 6W8944 Receptacle onto the end of the Unit Connector and reassemble the CMS to the dash. The 98OF Unit Connector harness can be accessed from under the dash on left hand side. Rework the 6W8944 Receptacle as described above.GOSSELIES WHEEL LOADER TEAM COPYRIGHT 1994 CATERPILLAR ALL RIGHTS RESERVED