INDICATOR 1908438 - Caterpillar

Introduction
Adjust the negative flow control if the flow test results differ greatly from the specification.Adjustment Procedure
Illustration 1 g02100279
Pump Compartment (1) Adjustment screw (2) Locknut (3) Adjustment screw (4) LocknutNote: Use the same procedure for both pumps. Use locknut (2) and adjustment screw (1) to adjust the drive pump. Use locknut (4) and adjustment screw (3) to adjust the idler pump.
Loosen locknut (2) .
Turn adjustment screw (1) until the negative flow rate is adjusted to the correct specification.Note: A clockwise adjustment of adjustment screw (1) and adjustment screw (3) increases the flow rate. A counterclockwise adjustment decreases the flow rate. Note: A quarter turn of adjustment screw (1) will change the flow rate approximately 21.5 L/min (5.7 US gpm) which is approximately 100 kPa (15 psi).
Tighten locknut (2) to a torque of 16 N m (12 lb ft).
Adjust the idler pump. Use locknut (4) and adjustment screw (3) to adjust the idler pump.