INDICATOR-DIG 1984234 - Caterpillar

Illustration 11 g06271963
Install spherical bearing (19), plate (15), plate (20), and eight bolts (16). Tighten bolts (16) to a torque of 270 25 N m (200 18 lb ft).
Install thrust washer (14) onto pin (17). Install pin (17) into spherical bearing (19).
Install ring (18) onto pin (17).
Apply Tooling (B) to the inside diameter of caps (13). Install caps (13).
Install plate (21) onto pin (17) without the shims using three bolts (22) spaced 120 degrees apart. Tighten those bolts to a torque of 200 25 N m (148 18 lb ft). Measure the distance between pin (17) and plate (21). Shim pack (23) should be equal to that distance plus 0.25 mm (0.0098 inch).
Remove bolts (22) and plate (21).
Install the shim pack (23) that was determined in Step5, plate (21), and bolts (22) onto pin (17). Tighten bolts (22) to a torque of 620 80 N m (457 59 lb ft).
Illustration 12 g00708076
Typical example
To avoid damage to the braking system, do not exceed 5447 kPa (790 psi) when applying pressure to release the parking brake.
Install Tooling (A) to the rear parking and secondary brake. Use Tooling (A) to release the parking brake.
Illustration 13 g00647681
Position a suitable lifting device on support assembly (11). Secure the suitable lifting device to a hoist.
Illustration 14 g00647683
Position a lift truck under the axle housing, as shown. Secure the lift truck to the axle housing. Use the lift truck and the hoist to install the axle housing and the support assembly onto the machine. The weight of the support assembly is 635 kg (1400 lb).
Illustration 15 g00647682
Install eight bolts (12) and the washers that hold support assembly (11) to the frame. Tighten bolts (12) to a torque of 1125 100 N m (830 74 lb ft).
Illustration 16 g00647679
Connect the wire harness to the magnetic wheel speed sensor. Install lockwire (10). Lockwire (10) must be 150 10 mm (6.0 0.4 inch) long. Install all clips that hold the wire harness to the axle housing and support assembly. Repeat for the other magnetic wheel speed sensor.
Illustration 17 g00708053
Apply 4C-5590 Anti-Seize Compound to the threads of two bolts (8). Repeat for the other side.
Position plate (9) and the spacer onto the rear spindle. Install two bolts (8) to a torque of 710 25 N m (524 18 lb ft). Repeat for the other side.
Illustration 18 g00647677
Illustration 19 g00647678
Connect hose assembly (6) and (7) to the axle housing. Connect clip (5) to the axle housing.
Illustration 20 g00647676
Connect four hose assemblies (1), (2), (3), and (4). Connect all the clips that hold the hose assemblies to the support assembly.
Fill the hoist, torque converter, and brake hydraulic tank with hydraulic oil. The capacity of the hoist, torque converter, and brake hydraulic tank is 503 L (133 US gal). Refer to the Operation and Maintenance Manual, "Hoist, Torque Converter and Brake Tank - Change".End By:
Install the lateral control rod for the rear axle housing. Refer to Disassembly and Assembly, "Lateral Control Rod (Rear Axle Housing) - Remove and Install".
Install