INDICATOR-COOL 2005229 - Caterpillar

1. Put tool (A) in between the two lips of seal (1) as shown. Move tool (A) along the seal to pull the locking lip of the seal out away from the cab. Move the tool completely around the circumference of the window assembly. 2. Remove clamps (2). Pull hose assemblies (3) clear of the window assembly. 3. Remove cab rear window assembly (4). 4. Remove seal (1) from the edge of the window opening.Install Cab Rear Window
1. Start along the side of the window panel opening to install seal (1).
TYPICAL EXAMPLE2. Install edge (3) of seal over panel (2) with the locking lip toward the outside of the cab.3. Install the seal around the circumference of the window opening. Cut the seal to extend past the starting point by .125 in. (3.18 mm) per foot of window opening circumference. Push the ends of the seal together and push them over the body panel to make a tight, smooth joint. When the window assembly is installed, edge (5) must be over window assembly (4) as shown. 4. Put the bottom of window assembly (6) in the channel of the seal as far as possible. Do not use too much force.5. Move in both directions from the starting point and lift the glass channel of the seal so the window assembly can slip into position.
TYPICAL EXAMPLE 6. Put a solution of soap and water on locking lip (7) of the seal.7. Install the curved end of tool (A) between the locking lip and groove (8) at any point away from the joint. Move tool (A) along groove (8) as shown until the locking lip is in its correct position around the circumference of the window assembly. 8. Put hose assemblies (9) in position on the cab. Install clamps (10).