INDICATOR 4234043 - Caterpillar

48. Remove the bolts that hold carrier (55) to manifold (57), and remove carrier (55) and gear (56) as an assembly. 49. Remove ring (58) from gear (56).50. Remove two rings (59) and ring (60) from carrier (55). 51. Remove ring (61) from gear (56), and remove the gear from carrier (55). 52. Remove manifold (57) from retainer (63).53. If necessary, remove dowels (62) from the manifold. 54. Remove shaft (41) and the bearing from retainer (63).55. Remove two rings (64) from the shaft. 56. Use a press to remove bearing (65) from shaft (41). 57. Remove O-ring seal (66) from retainer (63).Assemble High-Low Transmission
1. Clean and inspect all parts. Replace all of the parts that are worn or damaged. Put clean oil on all O-rings and seals. 2. Put O-ring seal (1) in position in the groove in retainer (2). 3. Use a press to install bearing (4) on shaft (3). 4. Put two rings (5) in position on shaft (3). 5. Position retainer (2) on blocks as shown, and install shaft (3) in the retainer. 6. If dowels (7) were removed from the manifold, install dowels (7) to a depth of 13.00 0.25 mm (.512 .010 in.).7. Align the bolt holes in manifold (6) with the holes in retainer (2), and put the manifold in position. 8. Install gear (9) in carrier (8), and install ring (10). 9. Install ring (13) and two rings (12) on carrier (8).10. Install ring (11) on gear (9). 11. Put carrier (8) and the gear in position on the manifold, and install bolts (14). 12. Attach a hoist and tool (A) to housing (15). Put housing (15) in position on carrier (8). 13. Install plug (16) in the shaft.14. Align the notch in the inside race of bearing (17) with the dowel in the carrier, and install bearing (17).15. Install snap ring (18) with tool (B). 16. Put rings (20) and (21) in position in the grooves of position (19). 17. Use two 3/8"-16 NC eyebolts, and install piston (19) in housing (15). 18. Put eighteen springs (22) in position in the piston. 19. Install ring (24) in the groove in piston (23). 20. Put piston (23) in position in piston (19), and install the bolts that hold it in place. 21. Install ring (25) on gear (26). 22. Put gear (26) in position in housing (15). 23. Install four discs (28) and three plates (27). Start with a disc. 24. Install ring (29) in the groove in shaft (3). 25. Put rings (30) and (32) in position in the grooves in piston (31). 26. Position housing (33) on blocks as shown.27. Install piston (31) in the housing with two 3/8"-16 NC eyebolts. 28. Install eighteen springs (34) in the piston. Be sure the rubber in pins (36) is not damaged. If the rubber is damaged, replace the pins.29. Put bearing (38) in gear (40). Put the gear and two discs (39) in position in carrier (37).30. Install