INDICATOR-PRESSURE 7E0027 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1P-0510     Driver Group     1    
B     1P-0808     Multipurpose Grease     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01029786
Install bearing (4) in pulley (5) .
Install lip seal (3) with Tooling (A), as shown. Apply Tooling (B) to the lip of the seal.
Install spacer (2) so the end with the taper is toward the inside of pulley (5) .
Install spacer (6) and bearing (9) in the front of pulley (5) .
Position O-ring seal (7) on the front of pulley (5). Install the pulley on shaft assembly (1) .
Install retainer (10) and bolts (11). Tighten bolts (11) to a torque of 25 6 N m (18 4 lb ft).
Install the fan adapter on pulley (5). Tighten bolts (8) to a torque of 47 9 N m (35 7 lb ft).
Fill the fan drive with Tooling (B) .End By: Install the fan drive. Refer to Disassembly and Assembly, "Fan Drive - Install".