INDICATOR-AIR FILTER CHANGE 7S0687 - Caterpillar

Before the exhaust temperature module can be used, the ETM must be configured for the installation. Most of the parameters can be programmed with the scanner's keypad. Other parameters are programmed at the factory.Note: When the configuration of the scanner is determined, record the information. Refer to the Testing and Adjusting, "Worksheet".Table 1 lists the configuration parameters that are programmable with the keypad.
Table 1
Configuration Parameters that are Programmable with the Keypad    
Number of engine cylinders ("CYLINDERS")    
Number of turbochargers ("TURBOS")    
Display only the turbocharger outlet temperature ("TURBO OUT").
Display only the turbocharger inlet temperature ("TURBO IN").
Display the turbocharger outlet and inlet temperatures ("TURBO OUT AND TURBO IN").    
Units for the display ("UNITS")    
Automatic scanning or manual scanning ("AUTOSCAN")    
Value for the scanner's filter ("FILTER VALUE")    
Setpoint for exhaust port temperature deviation ("SET CYL DEV")    
Setpoint 1 for high cylinder exhaust temperature ("SET CYL HI 1")    
Setpoint 2 for high cylinder exhaust temperature ("SET CYL HI 2")    
Setpoint 1 for high turbocharger outlet temperature ("SET TO HI 1")    
Setpoint 2 for high turbocharger outlet temperature ("SET TO HI 2")    
Setpoint for high turbocharger inlet temperature ("SET TI HI")    
Start-up timer ("SET TIMER")    
Arming temperature ("SET ARM TEMP")    Table 2 lists the parameters and the configurations that are programmed at the factory.
Table 2
Configuration Parameters that are Programmed at the Factory    
Parameters    Default Configuration    
Parameters for alarms for output switch 1     "SET CYL DEV"
"SET CYL HI 1"
"SET TO HI 1"
"SET TI HI"    
Parameters for alarms for output switch 2     "SET CYL HI 2"
"SET TO HI 2"    
Parameters for alarms that are armed by the arming temperature and the start-up timer     "SET CYL DEV"
"SET CYL HI 1"
"SET CYL HI 2"    
State of the output switches     Normally open
Nonlatching    
UNITS     Degrees C    
AUTOSCAN     Yes    
Combination locks (LOCK)     Not activated    
Cylinder Temperature Deviation (CYLDEVACTIVE)     Not activated    
Setpoint for exhaust port temperature deviation ("SET CYL DEV")     0 °C or 50 °C    
Set Cylinder HI 1 active (CYLHI1ACTIVE)     Not activated    
Setpoint 1 for high cylinder exhaust temperature ("SET CYL HI 1")     0 °C    
Set Cylinder Hi 2 active (CYLHI2ACTIVE)     Not activated    
Setpoint 2 for high cylinder exhaust temperature ("SET CYL HI 2")     0 °C    
High turbocharger outlet temperature 1 active (TO1ACTIVE)     Not activated    
High turbocharger outlet temperature 1 setpoint "SET TO HI 1"     0 °C    
High turbocharger outlet temperature 2 active (TO2ACTIVE)     Not activated    
High turbocharger outlet temperature 2 setpoint "SET TO HI 2"     0 °C    
High turbocharger Inlet Temperature active (TIACTIVE)     Not activated    
High turbocharger Inlet Temperature setpoint "SET TI HI"     0 °C    
CYLINDERS (1)     16    
TURBOS (2)     2    
Turbocharger channels (TURBOCHAN)     TURBO OUT    
FILTER VALUE     195    
Arming temperature "SET ARM TEMP"