INJECTOR GP-FUEL 10R1276 - Caterpillar

2. Turn the start switch key to START.
Inject starting aid (ether), ONLY while cranking the engine to avoid engine damage.Use sparingly, excessive ether can cause piston and ring damage.Use ether for cold starting purposes only.
3. Push the starting aid (ether) knob and release.4. Use additional starting fluid every two seconds until engine starts.5. Release the start switch key when the engine starts.6. Use starting aid every two seconds after the engine starts, until the engine is running smoothly.
After every 30 seconds of engine cranking, allow two minutes for the starting motor to cool before cranking again.
For starting below -18°C (0°F), use of additional cold weather starting aids is recommended. A coolant heater, fuel heater or extra battery capacity may be required.At temperatures below -23°C (-10°F), contact your Caterpillar dealer, or refer to Cold Weather Recommendations Operation & Maintenance Manual, SEBU5898, available from your Caterpillar dealer.Engine Starting with Jumper Cables
Batteries give off flammable fumes that can explode.Prevent sparks near the batteries. They could cause vapors to explode. Do not allow jump cable ends to contact each other or the machine.Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear eye protection when starting a machine with jump cables.Improper jump procedures can cause an explosion resulting in personal injury.Always connect battery positive (+) to battery positive (+) and battery negative (-) to battery negative (-).Jump only with a battery source and with the same voltage as the stalled machine.Turn off all lights and accessories on the stalled machine. Otherwise, they operate when the jump source is connected.
When starting from another machine, make sure the machines do not touch. This could prevent damage to engine bearings and electrical circuits.Turn on (close) the battery disconnect switch prior to the boost connection to prevent damage to electrical components on the stalled machine.Severely discharged maintenance free batteries do not fully recharge from the alternator after jump starting. The batteries must be charged to proper voltage with a battery charger. Many batteries thought to be unusable are still rechargeable.This machine has a 24 volt starting system. Use only the same voltage for jump starting. Use of a welder or higher voltage damages the electrical system.Refer to Special Instruction, Battery Test Procedure, SEHS7633, available from your Caterpillar dealer, for complete testing and charging information.
Use of Jumper Cables
When auxiliary start receptacles are not available, use the following procedure.1. Make initial determination as to failure of machine to crank. Refer to Special Instruction SEHS7768 on use of 6V2150 Starting/Charging Analyzer Group. Procedure applies even if machine does not have diagnostic connector.2. Place the transmission control in NEUTRAL on the stalled machine. Engage the parking brake. Lower all attachments to the ground. Move all controls to HOLD.3. On stalled machine, turn the start switch key to OFF. Turn OFF all accessories.4. On stalled machine, turn ON (close) the battery disconnect switch (if equipped).5. Move boost start machine near enough to stalled machine for cables to reach,