INJECTOR GP-FUEL 1388756 - Caterpillar

TYPE="TABLE" @@@--> 3. Add LLC if necessary to bring the coolant level to within 13 mm (1/2 inch) below the bottom of the fill tube or the correct level on the sight glass, if equipped. Upon initial fill the sight gauge can indicate an incorrect coolant level. Be sure the coolant is to the bottom of the fill tube. Recheck the coolant level and fill the cooling system to the bottom of the fill tube if the system was low.
In cold weather, frequently check the specific gravity of the coolant solution to ensure adequate protection.If the engine is to be stored in, or shipped to an area with freezing temperatures, the cooling system must be either protected to the lowest expected outside temperature or drained completely to prevent damage. Always check your cooling system before operating your engine. Depending on load, failure to operate with thermostats could result in either an overheating or an excessive cooling condition.
4. Check the condition of the filler cap gasket (if equipped). If the gasket is damaged, discard the old filler cap and install a new filler cap.5. Stop the engine and check the coolant to ensure it is at the proper level.Alternator (If Equipped)
Inspect/Rebuild or Exchange
Inspect the alternator for loose connections and correct battery charging. Inspect the ammeter gauge during engine operation to ensure batteries and/or electrical system is performing correctly. Make repairs as necessary. Refer to the Service Manual or contact your Caterpillar dealer.Caterpillar Recommendation
The most cost effective repair option is to rebuild with a repair kit that can be obtained from your Caterpillar dealer. To minimize downtime, Caterpillar recommends that the use of Remanufactured components (subject to availability) as a cost effective option.If there is a component you need, contact your Caterpillar dealer to see if it is offered under his Dealer Exchange Component Program.Removal and Installation
Refer to the established procedure in the Service Manual to remove and install the alternator or contact your Caterpillar dealer for assistance.Jacket Water Pump and Auxiliary Water Pump
Inspect/Rebuild or Exchange
Jacket water pump shown.Visually inspect the water pumps for leaks. If leaking is observed, replace all seals. Refer to the Service Manual for the procedure to replace the seals.Inspect the component for wear, cracks, pin holes and proper operation. If repairs or replacement is needed, see the Service Manual or contact your Caterpillar dealer.Air Starting Motor (If Equipped)
Inspect/Rebuild or Exchange
One unscheduled failure caused by your air starting motor will cost more in downtime than servicing your starting motor before failure.If you service your starting motor before failure, you will minimize unscheduled downtime. The prevention of unscheduled downtime saves you money and lowers your operating cost.Our recommended service intervals for performing preventive maintenance on your air starting motor are based on experience and accumulated data relative to the expectant life of the air starting motor and its components. These maintenance service intervals are provided for your use to economically schedule your repairs before failure.Failure to follow our recommendation could be costly to you, due to unexpected