INJECTOR AS-FUEL 2210030 - Caterpillar

Table 1
The Chart for the Battery Electrolyte    
Battery     Interval    
Conventional     100 Hour    
Low Maintenance     250 Hours    
Maintenance Free     -    Tighten the battery retainers on all of the batteries. Tighten the battery retainers at every 1000 hours.Check the following areas at a minimum interval of 1000 hours. Check the following areas more frequently during adverse conditions.
Illustration 1 g00370554
The battery access cover is located to the right of the operator's compartment. Open the battery access cover.
Illustration 2 g00289965
Clean the battery surface with a clean cloth.
Maintain clean battery terminals. You may use a coating of corrosion protection. Only use the corrosion protection after the battery cable is connected and after the battery cable is clean.
Coat the terminals with corrosion protection. Then, install the post cover.
For conventional batteries and batteries of low maintenance, follow these additional instructions:
Inspect the battery electrolyte level in each battery cell. A maintenance free battery does not require inspection.
Maintain the level of the distilled water to the bottom of the filler openings. If distilled water is not available, use clean drinking water.
A battery should not require more than 30 cc (1 ounce) of water per cell per week. This requirement should exist with the proper charging rate and with a moderate climate.
In extreme temperatures, check the water in the cells weekly. Cell water usage could be higher in extreme temperatures.
Close the battery access cover.