INJECTOR GP-FUEL 3282580 - Caterpillar

required level.
Repeat steps 4 through 8 until there are no active shutdown events remaining. When all active shutdown events have been reset, then the Red Shutdown Lamp will be turned off.
Press the escape key (9) three times in order to return to the "MAIN MENU" screen.Reset Individual Events from the Generator Set Control
Press the STOP key (6) .Note: The control must be in "STOP" in order to reset active shutdown events.
Use the scroll down key (12) in order to navigate from the "MAIN MENU" to the "EVENT LOG" menu.
Illustration 5 g01455471
Press the enter key (10) . An "ACTIVE EVENTS" screen will be displayed that will list the ECMs that are connected to the system. The total number of active events for an ECM is listed to the right of the ECM. Refer to Illustration 6.
Illustration 6 g01506375
Use the scroll down key in order to highlight an ECM that has active events. Refer to Illustration 6.
Illustration 7 g01455480
Press the enter key in order to display the active events for the selected ECM. Refer to Illustration 7.Note: The events are sorted from top to bottom. For example, the highest priority events will be listed at the top of the event log.The state of the event , the priority level, and the event types that are associated with a specific event are listed in Table 1.
Table 1
Event State    Priority Level    Event Type    
Present (1)     Highest     Warnings
Shutdowns    
Active     Medium     Shutdowns    
Inactive     Lowest     Warnings
Shutdowns    
( 1 ) Does not apply to external modules
Scroll through the events in order to highlight an active event.
Ensure that the condition which caused the event is no longer present and then press the enter key.If the condition that caused the event is no longer present, and the control is in "STOP", then "RESET" will be highlighted.
Illustration 8 g01506377
Press the enter key again. The fault will clear. If there are no other active shutdown events, then the red shutdown lamp will turn off.
Repeat steps 4 through 8 until there are no active shutdown events remaining. When all active shutdown events have been reset, then the red shutdown lamp will be turned off.
Press the escape key (9) three times in order to return to the "MAIN MENU" screen.Resetting All Events for All Modules
Ensure that the control is "Stopped".
Execute the following from any screen. Press the "ACKNOWLEDGE" key and hold the "ACKNOWLEDGE" key for approximately 5 seconds.
A confirmation prompt will appear.
Illustration 9 g01455626
Press the enter key in order to continue to "RESET" all events on all of the modules. Press the escape key in order to "CANCEL" the reset operation.Note: "Reset All Events" will not reset "Present" events! For example, if the "E-Stop" switch is pressed and an EMERGENCY STOP SWITCH ACTIVATED SHUTDOWN is present. The event cannot be reset until the "E-Stop" is pulled out and the event status changes from "PRESENT" to "ACTIVE".Resetting Events for Engines Without J1939 Support
The EMCP 3 generator set control (GSC) support that is provided for engine events,