3707281 INJECTOR GP-FUEL Caterpillar parts
C4.4, C7.1
Rating:
Alternative (cross code) number:
CA3707281
370-7281
3707281
CA3707281
370-7281
3707281
Weight: 0.100 pounds 0 kg.
GENERATOR SET, INDUSTRIAL ENGINE,
Related part:
3707281
INJECTOR GP-FUEL
20R2477
R
You can buy:
US$245.60
28 May 2025
FridayParts
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
6 Bags Common Rail Injector Repair Kit For 23670-E0600 23670-E0590 12640381 12644527 4336862 3707280 3707281 - (Style: A, Color: For 4336862)
Generic Color: For 4336862
Generic Color: For 4336862
ZLPSFCSM 1X Fuel Injector 3707281 Compatible for Caterpillar CAT CS-64B CB-66B CP-54B CB-64B CS-54B CS-66B CB-68B Vibratory Compactor CCS9 CB13 CB15 CB16 Compactor
ZLPSFCSM Product Name: Fuel Injector || Product Number:3707281 || Application:Compatible for Caterpillar CAT CS-64B CB-66B CP-54B CB-64B CS-54B CS-66B CB-68B Vibratory Compactor CCS9 CB13 CB15 CB16 Compactor
ZLPSFCSM Product Name: Fuel Injector || Product Number:3707281 || Application:Compatible for Caterpillar CAT CS-64B CB-66B CP-54B CB-64B CS-54B CS-66B CB-68B Vibratory Compactor CCS9 CB13 CB15 CB16 Compactor
1PCS Fuel Injector 3707281 Fits for Caterpillar CAT CS64B CB66B CP54B CB64B CS54B CS66B CB68B Vibratory Compactor CCS9 CB13 CB15 CB16 Compactor
EXKATCC Product Name: Fuel Injectors || Replace Number:3707281 || Application:Fits for Caterpillar CAT CS64B CB66B CP54B CB64B CS54B CS66B CB68B Vibratory Compactor CCS9 CB13 CB15 CB16 Compactor
EXKATCC Product Name: Fuel Injectors || Replace Number:3707281 || Application:Fits for Caterpillar CAT CS64B CB66B CP54B CB64B CS54B CS66B CB68B Vibratory Compactor CCS9 CB13 CB15 CB16 Compactor
Information:
Illustration 1 g02149381
Connections of the ripper shank lower solenoid
This diagnostic code is associated with the ripper shank lower solenoid. The FMI 06 means that the ECM has determined that there is a short to ground.The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is shorted to ground.
The solenoid has failed.
The ECM has failed. An ECM failure is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0888 - FMI 06 is active before performing this procedure.Note: Use a digital multimeter for the measurements in this procedure.Test Step 1. Check the solenoid
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness. Expected Result:The FMI 06 changes to FMI 05 after the solenoid is disconnected.Results:
YES - The FMI 06 changes to FMI 05 after the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Replace the solenoid. Verify that the new solenoid has corrected the problem.STOP
NO - The FMI 06 remains active. Proceed to Test Step 2.Test Step 2. Check the energize circuit of the solenoid for a short to ground
Turn the key start switch and the disconnect switch to the OFF position.
The solenoid remains disconnected from the machine harness.
Disconnect the machine harness connectors from the ECM.
At the machine harness connector, measure the resistance from the signal contact J1-59 wire (J914-PU(Purple)) to all contacts that are used in the machine harness connectors for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
YES - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NO - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J1-59 wire (J914-PU(Purple)) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. Check the status of the diagnostic code
Inspect the harness connectors. Clean the contacts of the harness connectors and check the wires for damage to the insulation. Damage is caused by excessive heat, corrosion, or chafing.
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the circuit.
Reconnect all harness connectors in order to make sure that the connectors are fully seated. Also, make sure that the clips for each connector are fastened.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Determine if the CID 0888 - FMI 06 diagnostic code is active. Expected Result:The CID 0888 - FMI 06 diagnostic code is not active.Results:
YES - The CID 0888 - FMI 06 diagnostic code is not active. The problem does not exist at this time.Repair: The initial diagnostic code was probably caused by a poor
Caterpillar parts catalog:
Parts injector Caterpillar catalog:
3443312
INJECTOR GP-FUEL
C4.4, C7.1
C4.4, C7.1
3707286
INJECTOR GP-FUEL
316E L, 318E L, 430F, 450F, C4.4, CB-44B, CB-54B, CP-54B, CS-54B, CS-64B, CW-34, D5K2 XL
316E L, 318E L, 430F, 450F, C4.4, CB-44B, CB-54B, CP-54B, CS-54B, CS-64B, CW-34, D5K2 XL
3443314
INJECTOR GP-FUEL
120M 2, 2570C, 2670C, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 563C, 573C, 950K, 962K, BG1000E, BG1055E, C7.1
120M 2, 2570C, 2670C, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 563C, 573C, 950K, 962K, BG1000E, BG1055E, C7.1
3443316
INJECTOR GP-FUEL
2384C, 2484C, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323E L, 525D, 535D, 545D, 555D, 559C, 579C, 924K, 930K, 938K, C6.6, C7.1, D6K2 LGP, D6N LGP, D6N OEM
2384C, 2484C, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323E L, 525D, 535D, 545D, 555D, 559C, 579C, 924K, 930K, 938K, C6.6, C7.1, D6K2 LGP, D6N LGP, D6N OEM
3323079
INJECTOR GP-FUEL
316E L, 318E L, 430F, 450F, C4.4, CB-44B, CB-54B, CP-54B, CS-54B, CS-64B, CW-34, D5K2 XL
316E L, 318E L, 430F, 450F, C4.4, CB-44B, CB-54B, CP-54B, CS-54B, CS-64B, CW-34, D5K2 XL
3707280
INJECTOR GP-FUEL
120M 2, 2570C, 2670C, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 563C, 573C, 950K, 962K, BG1000E, BG1055E, C4.4, C4.4XQ100, C7.1, CP-68B, CP-74B, CS-56B, CS-66B, CS-76B, CS-78B
120M 2, 2570C, 2670C, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 563C, 573C, 950K, 962K, BG1000E, BG1055E, C4.4, C4.4XQ100, C7.1, CP-68B, CP-74B, CS-56B, CS-66B, CS-76B, CS-78B
3707282
INJECTOR GP-FUEL
2384C, 2484C, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323E L, 525D, 535D, 545D, 555D, 559C, 579C, 924K, 930K, 938K, C6.6, C7.1, D6K2 LGP, D6N LGP, D6N OEM
2384C, 2484C, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323E L, 525D, 535D, 545D, 555D, 559C, 579C, 924K, 930K, 938K, C6.6, C7.1, D6K2 LGP, D6N LGP, D6N OEM
20R1282
INJECTOR GP-FUEL
3512, 3512B
3512, 3512B
10R8987
INJECTOR GP-FUEL
3512B
3512B
10R7235
INJECTOR GP-FUEL
3516B
3516B
10R7237
INJECTOR GP-FUEL
3512B, 3516B
3512B, 3516B
20R1277
INJECTOR GP-FUEL
3516B
3516B
20R1283
INJECTOR GP-FUEL
3508B, 3516, 3516B
3508B, 3516, 3516B
1180225
INJECTOR AS
3508B, 3512B, 3516B
3508B, 3512B, 3516B
7E3384
INJECTOR GP-FUEL
3508, 3512, 3516
3508, 3512, 3516