INJECTOR GP-FUEL 3969626 - Caterpillar

2. Remove cam bearing No. 7 (the rear cam bearing) as follows:a. Screw the 8M-8778 Stud into the 9U-7222 Cam Bearing Pilot. b. Insert the small diameter of Cam Bearing Pilot Tool (B) into the cam bearing as shown.c. Position Tooling (A) on the back of the cylinder head as shown. Note that the cylinder is rod retracted, and positioned against the cylinder head.d. Screw the 6V-4013 Threaded Rod into Tool (B). Install the 5P-8248 Washer and 2J-3506 Nut. Screw the 2J-3506 Nut on the 6V-4013 Threaded Rod until it contacts the cylinder. e. Actuate the hydraulic cylinder to remove the cam bearing from the cylinder head.f. Separate Tooling (B) from the 6V-4013 Threaded Rod. Remove the old cam bearing from Tooling (B).
Use the 9U-7223 Alignment Bushing when the 8S-8292 or 8S-8293 Extensions are attached to Tooling (B). The 9U-7223 Alignment Bushing will guide the extensions and help support weight of the tooling. Install 9U-7223 Alignment Bushing in the inside diameter of any cam bearing between the hydraulic cylinder and Tooling (B).
Example: Tooling (H) used to remove No. 1 camshaft bearing.3. Repeat Step 2 using Tooling (B) and:a. Tooling (C) to remove camshaft bearing No.6.b. Tooling (D) to remove camshaft bearing No.5.c. Tooling (E) to remove camshaft bearing No.4.d. Tooling (F) to remove camshaft bearing No.3.e. Tooling (G) to remove camshaft bearing No.2.f. Tooling (H) to remove camshaft bearing No.1 (front camshaft bearing).Install Camshaft Bearings
Make sure inside of the cylinder head is clean. Check the cam bores to make sure there are no burrs. Put a thin film of clean engine oil inside of the cam bearing bore and on each new camshaft bearing prior to installing.
The procedure to install the cam bearings is the same for each of the bearings. However, each bearing requires a different combination of tooling. The depth that the camshaft bearing is installed into the cam bore is controlled by the tooling. All bearing depths are the same EXCEPT for the No.1 camshaft bearing. Be sure to use the correct tooling when installing the camshaft bearings. 1. Do the following to install camshaft bearing No.7:a. Screw the 8M-8778 Stud into the 9U-7222 Cam Bearing Pilot.b. Install the camshaft bearing on the 9U-7222 Cam Bearing Pilot. Note the camshaft bearing fits over the small diameter of the 9U-7222 Cam Bearing Pilot, and is held in place by the 9U-7213 Backup Plate and OS-0509 Bolt. Make sure the 9U-7213 Backup Plate is positioned with the large chamfer contacting the camshaft bearing as shown.c. Insert the large diameter of cam bearing pilot Tool (B) into the cam bearing bore as shown. d. Attach Tooling (A) to Tooling (B) with the 6V-4013 Threaded Rod and 2J-3506 Nut. Screw the 2J-3506 Nut on the 6V-4013 Threaded Rod until it contacts the hydraulic cylinder. Note that the cylinder is rod retracted, and positioned against the cylinder head. e. Actuate the hydraulic cylinder to pull the camshaft bearing into the cam bore. When the chamfer of Tooling (B) contacts the