INLAY 3Y0962 - Caterpillar

Illustration 27 g03671347
Place Tool (A) on the surface of main screed plate (4) and the outside end of the extender screed plate (3).
Illustration 28 g03671362
Use Tool (D) to measure the gap between Tool (A) and the leading edge of the outside of extender screed plate (3). For the correct angle of attack, the gap should be 2 mm (0.08 inch) to 3 mm (0.12 inch).
If outboard angle of attack adjustment is required, use the outboard angle of attack adjuster only. If height adjustment is necessary, the height adjustment chain must be disconnected. If height adjustment is necessary for the right extender, go to Step 12. If height adjustment is necessary for the left extender, go to Step 15. Note: Do not use the slope control or height control to adjust screed height on the outboard side. Do not adjust the inboard angle of attack adjuster.
Illustration 29 g03671465
Loosen locknut (17) and locknut (14).
To increase the angle of attack, turn bolt (16) clockwise. To decrease the angle of attack, turn bolt (16) counter-clockwise.
Tighten locknut (17) and locknut (14) to a torque of 280 N m (206 lb ft).
Refer to the following steps in order to access the manual height adjust chain on the left extender.
Illustration 30 g03671448
Loosen belt (18) and remove covers (19).
Illustration 31 g03671455
Remove four bolts (20) and washers. Remove cover plate (21).
Refer to the following steps in order to access the height adjust chain on the right extender.
Illustration 32 g03695940
Remove six bolts (22) and washers. Remove cover plate (23).
Illustration 33 g03671459
Loosen lock nut (26), chain tension bolt (25) and motor mounting bolts (27) in order to relieve the tension of height adjustment chain (24).
Illustration 34 g03671461
Locate and remove master link (29). Separate height adjustment chain (24).
Turn outboard height adjuster (28) to raise or lower the extender. Turn the adjuster clockwise in order to raise the extender. Turn the adjuster counter clockwise in order to lower the extender.
Connect height adjustment chain (24) and connect master link (29).
Tighten bolt (25) until height adjustment chain (24) has a deflection of 6 mm (0.25 inch). Tighten lock nut (26).
Tighten motor mounting bolts (27).
Position the cover plates and secure the bolts. Screed Plate Extender Flatness Adjustment
Illustration 35 g03673889
Place Tool (A) along the trailing edge of extender screed plate (3).
Illustration 36 g03671478
If the trailing edge of the extender screed plate is not flat, reset the inner trailing edge adjusters (7). Do not disturb the outer adjusters.
Loosen nut (8) on top of trailing edge adjusters (7). Turn the trailing edge adjuster counter-clockwise to retract the adjuster.
Tighten nut (8). Reset the Scales
Illustration 37 g03671581
Loosen jam nuts (30) and move indicator (32) to the zero mark on extender height scale (31). Tighten the jams nuts.
Illustration 38 g03671586
Loosen jam nuts (35) and move indicator (34) to the zero mark on extender slope scale (33). Tighten the jams nuts.