INSERT-VALVE SEAT 7W9779 - Caterpillar

TYPE="1" START="1">
Calculate payload cycle information and store the payload cycle information.
"Time stamp": The "Date/time" that marks the start of the payload cycle.
"Payload": The weight of the material that is being moved
"Loading Time": The amount of time that is required to load the truck
"Loading Time": The amount of time that is required to load the truck
"Stopped Empty Time": The "total time" that is recorded for a truck that is "stopped while empty"during the payload cycle
"Traveling Empty Time": The "total time" that is recorded for a truck that is "travelling while empty"during the payload cycle
"Travel Empty Distance": The "total distance" travelled by the truck while the truck was empty.
"Stopped Loaded Time": This is the time that is recorded when a truck with a full load is not moving during the payload cycle.
"Traveling Loaded Time": This is the time that is recorded when a truck with a full load is moving during the payload cycle.
"Transmission Shifts": This is the total number of transmission shifts "up or down" that were made during the payload cycle.
"Fuel Used": This is the total fuel that is used during the payload cycle.
"Operator ID": This is the identification number of the operator that had dumped the load for that payload cycle. The operator must enter this number into the VIMS via the VIMS keypad module.
Calculate resettable totals and store resettable totals.
The total number of loads that were hauled since the last reset
The total weight that was hauled since the last reset
Total travel distance since the last reset
Total travel time since the last reset
Provide a way to download onboard information to the off-board system for analysis.
Provide a way to calibrate the system via the VIMS keypad module.
Provide a way to configure the system to specific requirements of the user.
Set the maximum payload weight.
Turn on/off last pass indicators.
Turn on the Maximum Payload Speed Manager. Turn off the Maximum Payload Speed Manager.
Set the event limits for the Road Analysis Control (RAC).
Display payload information on the message center as the truck is being loaded.
Payload weight
Loading status messages
Display loading status information with the payload status lamps as the truck is being loaded.
Loading
Last pass
Fully loaded
The following payload information is made available to broadcast:
Loader pass count
Last pass indicator
Cycle data
Calculate the parameters (per payload cycle) and then display the parameters that are listed here:
Payload weight
Payload status ("travelling, empty, etc.")
Haul distance.
Automatically adjust for the weight of an empty truck as operating conditions change.
Fuel level
Carryback that is in the body of the truck or carryback that is stuck to the underside of the machine
Detect incorrect suspension cylinder charge (collapse) and cause an appropriate event.