INSERT 8T2687 - Caterpillar

start by: a) remove hydraulic oil cooler core1. Remove both hood sections and hood support. 2. Fasten a hoist and remove the two front radiator guards (1). 3. Remove baffle (2) from the sides and bottom of radiator core. On some early models, a six in. (15.2 cm) piece of the bracket for the baffle must be removed from the bottom end to get enough clearance to remove the radiator core. 4. Remove bolts and clamps (4) located at the bottom of the radiator.5. Disconnect the water outlet elbow (3) from bottom of radiator. 6. Disconnect light wires (6) from the top tank.7. Remove the four bolts (7) from the top tank.8. Remove water bypass lines (5) and (8).9. Install tooling (A) in the radiator top tank with one spacer and five washers on each side. Fasten a hoist and remove the radiator core. Weight is approximately 700 lb. (317.5 kg).Install Radiator Core
1. Fasten a hoist to tooling (A) and put the radiator core into position in the guard. Remove tooling (A) from top tank. 2. Connect the light wires (1) to the top tank.3. Install the four bolts that hold the top tank to the guard.4. Install the two bypass lines on top tank. 5. Install the two lower clamps (2) and bolts.6. Connect the water elbow to the lower tank.7. Install a baffle on each side and bottom of radiator core. 8. Install the two radiator guards (3).9. Install hood support and both hood sections.end by: a) install hydraulic oil cooler core